Panasonic RP-BT10-W Operating Instructions Manual

Also see for RPBT10 - DIGITAL WIRELESS EARPHONE: Operating instructions

Contents

RQT899326Problem Possible cause and suggested remedyThe rechargeable battery ishot while it is being charged. The battery will become somewhat hot: this is normal and not indicative of trouble.I can’t connect a deviceeven though I havealready registered it. ®>• Re-register the transmitter and receiver pairing.1, Connect the transmitter to the iPod ®.2, Press and hold the transmitter button for 2 seconds.The transmitter’s lamp (red) starts blinking rapidly.3, Press and hold the MIC button on the receiver for 2 seconds.The receiver’s power is now turned on, and the lamp (red) blinks slowly.4, Press and hold the [–] button on the receiver for 6 seconds.The receiver and transmitter lamps (red) start blinking rapidly.• When re-registering the pairing: Wait for about 7 seconds. Step 5 is not necessary.• When registering the pairing for the first time (when replacing the unit with anew one): Go to step 5.5, Press the transmitter button twice quickly.When the pair setting has been re-registered, the transmitter lamp (blue) andreceiver lamp (blue) will blink slowly.If failed, power off both devices and try again.Re-register the cellphone and receiver pairing. Refer to “Registering the device pair”on page 18.Charging is not terminatedeven though the time fora complete charging haselapsed.This process may take approximately 3 hours or so depending on the level of thebattery’s remaining charge.Charging stopsimmediately.To prevent overcharging, repeated charging is not possible.Before charging again after fully charging, use the unit for at least 20 to 30 minutes.(If charging is restarted immediately after fully charging, charging will automaticallystop after about 1 minute.)Troubleshooting