Panasonic PV-D4752 Operating Instructions Manual

Also see for PVD4742 - DVD/VCR DECK: Operating instructions Operating instructions Operating instructions Service manual

Panasonic PV-D4752 Operating Instructions Manual Manual pdf 10 page image

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.comLocation of Controls (continued)Rear View of DECKAC Power PlugS-Video OutConnector(DVD Only)p. 10, 13Component Video OutputConnector (Y, P B , P R ) (DVD Only)p. 13Audio Output 2Connector (L/R)p. 13Optical Digital AudioOutput Connector(DVD Only)p. 15Video InputConnectorp. 35Video OutputConnectorp. 12Audio InputConnector (L/R)p. 35Audio Output 1Connector (L/R)p. 12VHF/UHF Antenna Input Terminalp. 12VHF/UHF Antenna Output Terminalp.12DVD OUTPUTDIGITALAUDIO OUT(PCM/BITSTREAM)OPTICAL S-VIDEO OUTSELECTCOMPONENTVIDEO OUTYPBPRLRVIDEOAUDIO1LROUT IN1 IN FROM ANT.OUT TO TVVHF/UHFOUTAUDIO2SEE MANUAL• While plugged into an AC outlet,this DECK consumes 4 W ofelectrical power in off mode.• •The following table shows the status of the output jacks when in VCR or DVD mode.Bold: VCR FunctionItalic:DVD FunctionBold Italic:VCR and DVD FunctionsNote • PROG functions on the remote are not available when using Component Video Outputand S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then pressPROG.SELECT SW (DVD Only)p. 13Video OutputAudio Out 1Audio Out 2ComponentVideo OutputS-VIDEO OUTVCRDVDYESYESN/A N/ATo enjoy PROGRESSIVE SCAN video (PV-D4752 only)(1). ConnectComponent Video Output to the component video input terminals of a television.(See p. 13.)(2). Set the “COMPONENT VIDEO OUT”/“S-VIDEO OUT”SELECT SWITCH, in the back of theDECK, to “COMPONENT VIDEO OUT.” (See above.)(3). When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and thePROGRESSIVE SCAN signal is output from theComponent Video Output Connector.Note• The PROGRESSIVE button can be operated when the DECK is in DVD function mode.• The screen may shift off-center when using progressive output. Please adjust the screenposition if this occurs. (Refer to your TV manual.)• The unit does not output video signals from the “VIDEO OUT” or “S-VIDEO OUT” terminalswhen the ON lamp is lit.YESSELECT SW (Switchable)➛YES ➛