Panasonic PP105168 Operating Instructions Manual

23Notes:¡ We shall not guarantee all the functions of theBluetooth ® device to be connected. When opera-tions cannot be performed via this unit, operatethe system via the Bluetooth® device.¡ Be aware that the battery of a Bluetooth® devicedrains faster if the Bluetooth® device is con-nected to this unit.¡ Even when the Bluetooth® device that is con-nected to this unit is located near this unit,sound may be interrupted or noise may begenerated.¡ The Bluetooth® device with over 5-digit PIN codeis not operated with this unit.¡ “B/T DISCOND is displayed when the Bluetooth®device is disconnected.Setting of PIN (Personal Identity Number) code1 Hold down [6] for more than 2 secondsto call the PIN code entry mode.2 Press [6] to prepare for adjustment.1st digit blinks3 Enter a number for each digit.[s] / [d] : Selects number (0 – 9).[6] : Selects next digit to be entered.Digit entered4 Press [6] to determine the PIN codeentry when last digit is entered.CompletedNote: To check the Bluetooth ® address of this headunit, press [SEL] after step 1.Connection of the registeredBluetooth ® device to this unit1 Press the preset button(s) [1] through[6] to select the registration number ofthe Bluetooth® device of interest. (Referto the above.)2 Hold down [BAND] for more than 2seconds for connection.The Bluetooth ® indicator ( ) lights.Notes:¡ Even if [SRC] (Source) is pressed to change thesource, the connection stays connected.¡ Depending on the communication status, it maytakes 5 to 40 seconds for device connection.Disconnection of the Bluetooth ® deviceHold down [BAND] for more than 2 seconds.The Bluetooth ® indicator ( ) turns off.Note: When the Bluetooth® device is out of receptionrange or encounter serious interference by outersignal, “ERROR” appears and this unit will automati-cally disconnect the connections.Deletion of the registered data1 Press the preset button(s) [1] through[6] to select a registration number as-signed to the Bluetooth® device whosedata is to be deleted. (Refer to theabove.)2 Hold down the preset button [1]through [5] selected above for theregistration number for more than 2seconds.3 Press the preset button that waspressed at the step above again.4 Push [SEL].Deletion completed