Panasonic NV-GS320 Operating Instructions Manual

Also see for NV-GS320: Operating instructions Operating instructions

Contents

Before using15VQT1A47Quick StartWhen quick start is ON the battery power is stillbeing consumed, even when the LCD monitorand the viewfinder are closed.The movie camera will resume recording/pausemode about 1.7 seconds after the LCD monitor orthe viewfinder is reopended.≥Please note in quick start mode approximatelyhalf the pause recording power is beingconsumed. Using quick start mode will reducethe battery recording/playback time.≥This is only activated in the following cases.≥While using the batteryA tape or a card is inserted, while the TapeRecording Mode is set.A card is inserted, while the Card RecordingMode is set.≥While using the AC adaptorquick start can be used even if a tape/cardis not inserted.≥Set to Tape/Card Recording Mode.1 Set [SETUP] >> [QUICK START] >> [ON].(-20-)2 While the [OFF/ON] switch is still set to[ON], close the LCD monitor and retract theviewfinder.≥The Status indicator lights green and the unitgoes into quick start standby mode.≥The movie camera will not go into quick startstandby unless the LCD monitor is closed andthe viewfinder is retracted.3 Open the LCD monitor or extend theViewfinder.≥The Status indicator lights red and thecamera is put into recording pause approx.1.7 seconds after it is turned on.ª To cancel Quick Start1 Set [SETUP] >> [QUICK START] >> [OFF].(-20-)≥If the [OFF/ON] switch is set to [OFF] while theunit is in quick start standby, the power turns off.≥If the standby continues for approx. 30 minutes,then the Status indicator will go off and thecamera will be completely turned off.≥In the following cases, quick start is cancelledand the power turns off.≥When the Mode dial is moved.≥When the battery or AC adaptor is removed.≥When both the tape and card are removedwhile using the battery in Tape RecordingMode.≥When the card is removed while using thebattery in Card Recording Mode.≥When the camera is quick-started with the whitebalance on automatic, it may take some timeuntil the white balance is adjusted if the scenebeing recorded has a light source different fromthe scene last recorded. (When the colour nightview function is used, however, the whitebalance of the scene last recorded is retained.)≥If the power is turned on in quick start standby,the zoom magnification becomes 1k and thepicture size may differ from what it was beforequick start standby.≥If [POWER SAVE] (-62-) is set to [5 MINUTES]and the unit automatically goes into quick startstandby mode, set the [OFF/ON] switch to[OFF], then to [ON] again. Also, close the LCDmonitor and retract the viewfinder and thenopen the LCD monitor or extend the viewfinderagain.OFF ONOFF ON