Panasonic NV-FJ620 Operating Instructions Manual

Also see for NV-FJ620: Operating instructions Operating instructions

Panasonic NV-FJ620 Operating Instructions Manual Manual pdf 6 page image

6Example:3 Press the MENU button U to finish the setting mode.4 Retune your TV to the new RF channel for the VCR.Note:– Even if the RF output channel has been changed, it is notnecessary to perform Auto Tuning.To Change the RF output ChannelIn some rare cases after tuning the TV to your VCR,interference may be visible on the picture. To get rid of thisinterference, you can manually adjust the RF output channela few channels up and down from the current setting. Theprocedure is described below.Operations1 Hold down MENU button U for 5 seconds or more.– The VCR display changes as shown below and theVCR picture on the TV displays this pattern.2 Enter the desired channel number (E21–E69) by theNumeric buttons 2 or the Channel button N.– Ensure that the VCR/TV switch E is set to [VCR].– Set the RF output channel of the VCR to [ss] (RF OFF)when the VCR is connected to the TV via the Audio/Video cable.Press the Channel button N to display [ss].Tuning the TV to Your VCRThe VCR supplies a signal to the TV via the RF coaxial cableon channel E21–E69.It is possible to view the video picture on your TV in the sameway that you watch TV broadcasts.If you have connected the VCR to the TV through the Audio/Video input sockets, then you do not need to follow theprocedure below.When the VCR is turned on after unpacking andconnecting the aerial cable and the mains lead, Plug inAuto Tuning starts automatically.Notes:– If the VCR is turned on with the aerial not connected, allchannels are skipped. Therefore, firmly connect the aerialand then turn the VCR off and on again to execute AutoTuning.– When Auto Tuning is cancelled halfway, Auto Tuning is notexecuted even if the VCR is turned off and then turned onagain. In this case, see page 7 [To Restart Plug in AutoTuning].Operations1 Turn on the TV and the VCR.2 Set the TV to an unused position which you wish to usefor your video playback.– Tune the TV until the display shown below appears onthe screen. (Please refer to the TV manufacturersoperating instructions regarding tuning.)– Set [RF SELECT] by pressing the Cursor buttons (21)S to select the colour TV system used by the TV set tobe connected.BG: PAL B.G.H/SECAM B.GI: PAL IDK: PAL D/SECAM D.K.K1M: NTSC (For NV-FJ620BD/BDX)3 Press the MENU button U.END: MENUAUTO TUNING ISCOMPLETED.RF SELECT:RF SELECT ≥ BG I DK MCH 22 SEARCHEND: MENU21AUTO TUNINGIN PROGRESS,PLEASE WAIT.On Screen DisplayDuring Plug in Auto Tuning After Plug in Auto TuningPanasonic VCREND: MENURF SELECT:RF SELECT ≥ BG I DK MExample2 828:VCR display(RF OFF)21ss69