9EnglishInstallationInstalling the refrigeratorThe refrigerator comes on four casters to enable it to be moved easily.Carefully read through the section “Choosing the right location”, and install the refrigerator in the best location.Once the installation location has been decided upon, secure the refrigerator, and adjust it so that it is level.Removing the front grilleWhen the two doors are opened and the front grille is viewed fromabove, two screws – one on the left and the other on the right – willbe seen.Turn these screws counterclockwise, and remove them.There is a connecting area slightly to the right of the centre of thefront grille at the bottom. Take hold of this area, and pull the grilletoward you to remove it.Front grilleConnecting areaSecuring the refrigeratorInsert a flat screwdriver into a slot on the adjustable legs at the leftand right, turn them in the direction shown by the arrows to lowerthe legs to the floor level, and then secure the legs firmly.Adjustable legsLevelling the refrigeratorTurn the adjustable legs so that the refrigerator is installed flush with the floor.If the left and right doors are not flush with each other, turn one of the adjustable legs, and bring the doorsinto alignment.If the left door is lower than the right doorInsert a flat screwdriver into a slot on theadjustable leg on the left, turn it in the directionshown by the arrow, and adjust.If the right door is lower than the left doorInsert a flat screwdriver into a slot on theadjustable leg on the right, turn it in the directionshown by the arrow, and adjust.Attaching the front grilleFollow the steps for removing the grille in their reverse order.