388 Test ModeEach test mode needs to perform the following procedures incommon.1. Plug off or power supply off.2. Power supply on after short-circuiting the appointedpositions.3. Test mode ends, plug off or power supply off and removethe short-circuiting points.8.1. Compulsion FC Defrost ModeCompulsion FC defrost: To be making short-circuit of No.75 pin(TEST 1) and GRD in IC1.• Normal control the same, without pre-cooling action, FCdefrost mode begins.• When FC defrost mode ends, changes the normal controlmode.8.2. Compulsion PC Defrost ModeCompulsion PC defrost: To be making short-circuit of No.70 pin(TEST 4) and GRD in IC1.• Normal control mode the same, without pre-cooling action,PC defrost mode begins.• When PC defrost mode ends, changes the normal controlmode.8.3. Change the Rotation Speed ofCompressorTo fix the rotation speed of compressor: To be making short-circuit of No.76 pin (TEST 0) and GRD in IC1. Then press " "button one by one.Rotation speed of compressor can select definite revel from R1to R6.