Panasonic NE-SCV2 Operating Manual

Also see for NE-SCV2: Operating instructions

14Operating GuideCommercial Microwave Convection OvenModel No. NE-SCV2This guide briefly describes the basic operation. Before using the product, please read the “ImportantSafety Instructions” in the Operating Instructions to use the product safely.Initial screenManual CookingMemory CookingPreheat① Use the preheating function to warm up the oven in advance.② Preheating will resume automatically every time cooking has finished once thepreheating has been set.Tools (p.4)Cooling the oven cavityThe inside of the oven can be cooled when the cavity is hot after cooking.How to set the AccessoriesOven Sheet (3 colors)Place on the Ceramic Plate only.Do not place on the Ribbed Plate.Place food on the Oven Sheet.OIt is recommended to replace it every 3to 6 months depending on the stain level.or(Select eitherdependingon the food.)Ceramic Plate (white)Place on the Wire Rack.Place food on the Ceramic Plate.Ribbed Plate (black)Place on the Wire Rack.Place food on the Ribbed Plate.OBe sure to use the ribbed platewith the ribs upward and orientedlike illustration.Wire RackPlace on the Ceramic Tray.Ceramic TrayPlace on the Base Plate Liner.Use as a drip tray for the food.Base Plate LinerPlace on the bottom surface of the oven.Use to prevent the food and oil stains.OIt is recommended to replace it every 3to 6 months depending on the stain level.OIllustrations may differ to the actual items.Place the rack so that it is withinthe tabs of the ceramic tray.A04203G81BPF1017-10119ToolsInitial screenMemory cookingMaintenance info.A total of all cooking hours is rounded down to the nearest hour.ex.) All cooking hours Display59 min 01 hr 59 min 1The last two figures of the total number of cycles are rounded down.ex.) Number of cycles Display99 times 0101 times 1001100 times 1100Change settingsThe settings of the beep●Loudness ●Length of beep ●Pitch of beep ●SoundsON: You can start cooking before preheating is complete.OFF: You cannot start cooking until preheat is complete.You can choose the brightness of the touch screen.You can change the preheat temperature displayed on the initialscreen.OPlease note that the preheat temperature previously saved for thememory cooking will also be changed if you change the setting here.Check memoryConfirm the following memory contents.●Memory cooking contents ●Beep settings ●Memory lock●Magnetron interval ●Maintenance intervalUse to confirm whether the contents of multiple SD MemoryCards are the same.The memory contents in the SD Memory Card are displayed asfour-figure alphanumeric characters.Memory lock (Default setting: Not displayed)Refer to the Operating Instructions.OWhen the memory lock is ON, Memory cooking and Change settings are not displayed.In such cases●Regular maintenanceA part replacement is required when a screen displays that it is time to perform the regular maintenance. Pleasecontact the dealer or a service agent promptly.●“F” code e.g. “F30” etc.If the “F” code does not disappear even after pressing the Stop/Reset pad, pull out the plug and then plug it inagain after 5 seconds.The oven is faulty if the “F” code still appears. Contact the dealer or a service agent.●The power turns off automaticallyThe initial screen of the display turns off automatically if it is not used for 5 minutes. (Auto Power OFF Function)Opening the door turns the power ON.

/ 2

Related manuals for Panasonic NE-SCV2