Panasonic NC-A701 Operating Instructions Manual

How to CleanEN16 EN17EnglishPlease check the following points before arranging for service.● Too much ground coffee has been put in.→ Ground ground coffee should not be put in more than7 level spoons.Button operationis invalid.Coffee cannot befiltered.Ground coffee is spilledfrom the filter.● Is the power plug loose?→Be sure to plug in the power plug.Brewing speed isslow or coffee is notcoming out.● Is there incrustant attached inside the machine?→Clean the pipeline with 20 g citric acid. (Page EN16)● I s the tank container filled with water?→ Please fill the water tank container with the watervolume according to the number of coffee cups.● Is the coffee basket put in?→Please put the coffee basket in.●I s the filter put in?→Please put the filter in.●Is the coffee jug installed correctly?→ Please install the coffee jug in the correct position.Coffee is spilledfrom the coffee jug.● Excessive water has been injected into the water tank.→Water filled in the tank should not exceed scale 6.There are coffee groundsin the coffee jug.● Bean container is not installed correctly.→Please reinstall the bean container.● Water tank is not filled with water.→ Please pour proper water volume in the tank.● The motor is locked.→ Please pull out the power plug and clean the beangrinding cavity.→ If the above actions cannot help troubleshooting,please contact Panasonic's direct service centre.● The filter is damaged.→Replace the filter.1. Press the button to select the Powder Port Cleaning Mode. When the on LCDscreen is on, press the button.2. After the "beep" sounds, the powder port willopen automatically. There will be ground coffeefalling, please pay attention.3. Open the coffee basket rack.6. After "Beep" for 8 times, the internal pipeline cleaning has finished.7. After use, it is recommended to repeat steps 2-6 with clear water to remove the odorof citric acid.4. Clean the powder port properly with a cleaning brush. Water droplets around thepowder port together with the ground coffee should be cleaned.5. Close the coffee basket rack and press the button to close the powder port.TroubleshootingPipeline CleaningProblem Cause and ActionPowder Port Cleaning1. Install coffee basket, coffee jug, bean container and otheraccessories (Please do not put ground coffee or beans in).2. Pour water into the water tank until it reaches the positionof scale 4.3. Pour 20 g citric acid into the water tank and stir it with asponge cleaning brush (Self-provided).4. Cover with the water tank lid and wait for 30 minutes.5. After plugging in the power plug, press the button toselect the cleaning mode for the internal pipelinecleaning. When the on LCD screen is on, press thebutton to start cleaning.Display shows "U11".Display shows "U13".Display shows "U12".● There may be ground coffee in the powder port.→ Please pull out the power plug and clean the powderport. (Page EN16)→ If the above actions cannot help troubleshooting,please contact Panasonic's direct service centre.Display shows "H04".