1 Getting Started1321-A Accessories(included)1-B Location of ControlsBattery ..............................oneHandset Cover ..................oneBelt Clip ............................oneCharger Unit .....................oneHandset Charger (with Clock Radio)Charge Contacts(1-F)VOLUMEControl (2-A)[TIME SET]Button (1-H)[SNOOZE/MUTE] Button (2-D, 4-C)Memory Buttons ([M1], [M2],[M3], [M4] and [M5]) (2-B)[FM/AM, RADIO] Button (2-A)[SLEEP] Button (3-A)[OFF] Button (2-A, 4-C)[+, -, TUNE/CLOCK]Button (1-H, 2-A)[BUZZER, ALARM SET]Button (4-B)[ALARM ON/OFF]Button (4-D)CHARGEIndicator (1-F)Display[RADIO, ALARM SET]Button (4-A)1-C Connecting the AC Adaptor/Setting Up the Loop AntennaStand the antenna up byinserting the tab into the slotuntil it clicks into place.•USE ONLY WITH Panasonic AC ADAPTOR PQLV1.•The AC adaptor must remain connected at all times. (It is normal forthe adaptor to feel warm during use.)•To disconnect the antenna, firmly pull theantenna cord, holding the cord near the plug.1-D Installing the Handset BatteryInsert the battery (#) and press it down until it snaps into thecompartment ($). Close the cover.1 2Power Outlet(AC 120 V, 60 Hz)AC Adaptor1-E Belt ClipYou can hang the handset on your belt or pocket using the includedbelt clip.To attach the belt clip To remove the belt clipWhile pressing the top of the clip(A), pull the right edge in thedirection of the arrow (B).LoopAntennaHeadset Jack(5-A)[Y] (TONE)Button[ ] (TALK)Button[ ] (Speaker-phone) Button[HOLD/INTERCOM]Button Charge Contacts(1-F)AntennaDisplay[OFF] Button[MENU] Button[REDIAL] ButtonSoft Keys (1-G)[FLASH/CALL WAIT]ButtonNavigator KeyRinger/MessageAlert IndicatorNote: The steps necessary to start up thehandset are described in these OperatingInstructions. Please read the KX-TG5200C/KX-TG5202C/KX-TG5230C/KX-TG5240C/KX-FPG391C operating instructions forfurther details about the handset operations.Make sure theAC adaptor plugis securelyconnected to theunit. Feed thecord through thehooks as shown.HookHooksGetting SAB