Panasonic KX-TG6412E Operating Instructions Manual

Also see for KX-TGA641: User manual Service manual Installation manual Installation manual Installation manual

Programming24 Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 83333 {V}/{^}: “Register H.set” iM4 Base unit:Proceed with the operation for yourmodel.■ KX-TG6411/KX-TG6412/KX-TG6413Press and hold {x} for about 5seconds. (No registration tone)■ KX-TG6421/KX-TG6422/KX-TG6423/KX-TG6424Press and hold {x} for about 5seconds, until the registrationtone sounds.L If all registered handsets startringing, press the same button tostop. Then repeat this step.L The next step must be completedwithin 90 seconds.5 Handset:Wait until “Base PIN” is displayed.i Enter the base unit PIN (default:“0000”). i ML If you forget your PIN, see page41.L When the handset has beenregistered successfully, w stopsflashing.Note:L When you purchase an additionalhandset, refer to the additionalhandset’s installation manual forregistration.Deregistering a handsetA handset can cancel its ownregistration (or the registration ofanother handset) that is stored to thebase unit. This allows the handset to endits wireless connection with the system.1 8 (middle soft key)2 {V}/{^}: “Base Unit Setup” iM3 {3}{3}{5}4 {V}/{^}: “Cancel Register” iML The numbers of all handsetsregistered to the base unit aredisplayed.5 Select the handset(s) you want tocancel by pressing the desiredhandset number. i ML The selected handset number(s)flashes.L To cancel a selected handsetnumber, press the number again.The number stops flashing.6 {V}/{^}: “Yes” i ML A confirmation tone sounds aseach handset numberdisappears.L The handset does not beep whencancelling its own registration.7 {ih}Increasing the range of thebase unitYou can increase the signal range of thebase unit by using a DECT repeater.Please use only the Panasonic DECTrepeater noted on page 4. Contact yourPanasonic dealer for details.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.L Do not use more than one repeater ata time.Setting the repeater mode1 8 (middle soft key)2 {V}/{^}: “Base Unit Setup” iM3 {V}/{^}: “Repeater” i M4 {V}/{^}: Select the desired setting.i M i {ih}TG6411-6421E(e).book Page 24 Tuesday, December 16, 2008 7:54 AM