2.3 ConnectPC Programming Manual 352.3.4 Connect—ModemConnects to the PBX in Interactive mode through the modem.To access the PBX remotely using this feature, an RMT card must be installed and the Remote—Analog Remote (Modem) Floating Extension Number assigned in 2.17.1 [11-1] Main.This option allows direct entry of connection parameters, for cases where the PC is used to connectto one or just a few PBXs, and an individual profile for each PBX is not necessary. If you connect tomultiple PBXs and would prefer to choose from among pre-saved profiles instead, see 2.4.11 Tool—Profile Setup for more details about creating profiles.To connect to the PBX by Modem1. From the Connect menu, select Modem.The Login window will be displayed.2. Select a connection option.• Select the Use profile check box if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.The Setup button will become unavailable.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to beentered.• Confirm that the Modem radio button is selected if you want to enter parameters manually.a. Click Setup.b. Modify the connection parameters as required. For more details, see the table below.c. Click OK.3. Click OK.Connection Settings for LAN (KX-TDA100/KX-TDA200/KX-TDA600 only)Setting Values ExplanationIP Address 1.0.0.0–223.255.255.255Specify the IP address of the PBX on the LAN.Enter the same IP address that was input in IPAddress of 2.7.27 [1-1] Slot—CTI-LINK CardProperty (KX-TDA100/KX-TDA200/KX-TDA600 only).Port Number 10000–65535 Specify the port number used to access thePBX via LAN. Enter the same port number thatwas input in Maintenance Port Number of2.7.27 [1-1] Slot—CTI-LINK Card Property(KX-TDA100/KX-TDA200/KX-TDA600 only).Connection Settings for ModemSetting Values DescriptionDial Number 1-9, 0, *, # and ","[comma]Enter the telephone number to be dialed toaccess the PBX.
