2.3 Connect34 PC Programming ManualTo connect to the PBX by USB1. From the Connect menu, select USB.The Login window will be displayed.2. Select a connection option.• Select the Use profile check box if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to beentered.• Select the USB radio button if you do not want to use a profile.3. Click OK.2.3.3 Connect—LAN (KX-TDA100/KX-TDA200/KX-TDA600 only)Connects to the PBX in Interactive mode through the Local Area Network interface of the PBX.A CTI-LINK card must be installed and the IP address of the PBX set to use this feature. For moredetails, see 2.7.27 [1-1] Slot—CTI-LINK Card Property (KX-TDA100/KX-TDA200/KX-TDA600only).This option allows direct entry of connection parameters, for cases where the PC is used to connectto one or just a few PBXs, and an individual profile for each PBX is not necessary. If you connect tomultiple PBXs and would prefer to choose from among pre-saved profiles instead, see 2.4.11 Tool—Profile Setup for more details about creating profiles.To connect to the PBX by LAN1. From the Connect menu, select LAN.The Login window will be displayed.2. Select a connection option.• Select the Use profile check box if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.The Setup button will become unavailable.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to beentered.• Select the LAN radio button if you want to enter parameters manually.a. Click Setup.b. Modify the connection parameters as required. For more details, see the table below.c. Click OK.3. Click OK.
