Panasonic KX-TDA0155CE Service Manual

Also see for KX-TDA0155CE: Service manual

Panasonic KX-TDA0155CE Service Manual Manual pdf 22 page image

22KX-TDA0155CE9 Measurements and Adjustments9.1. Version Check and CSID Writing9.1.1. Required Equipment1. (PC)Personal Computer with serial port (Windows 2000/98 or previous version)2. Power supply adaptor (PSZZ1TDA0142)3. Service JIG cable (PSZZ2CA155EU)4. AC Adaptor (KX-TCA1 / KX-A11 / PSLP1434) or Battery Box (PSZZTD142CE)5. TEL cord9.1.2. Preparation1. Remove the under cabinet (Refer to 7. Disassembly and Assembly Instructions)2. Remove 2 antennas from CN900 and CN901 (Refer to 7. Disassembly and Assembly Instructions)3. Remove the P.C.B from the upper cabinet (Refer to 7. Disassembly and Assembly Instructions)4. Connect PC to the CS by service JIG cable5. Start up the PC and start the hyperterminal6. Set the hyperterminal property as follows7. Set DIP switch pin 2 to 6 from OFF to ON.8. Supply a voltage to the TEL jack from the AC adaptor (KX-TCA1 / KX-A11 / PSLP1434 or Battery Box) via power supplyadaptor (PSZZ1TDA0142)serial port setupPort COM1Bit per second 19200Data bits 8Parity NoneStop bit 1Flow control Xon/Xoffserial port setupcheck next check boxiesASCII Receiving - Append line feeds to incoming line endsWarp line that exceed terminal width