2.2 System Programming76 General ProgrammingDefaultLV-MSG – H; GETMSG – *H; AA-SVC – #8; VM-SVC – #6Programming1. Enter 114.Display: 114 VM DTMF CMD2. Press NEXT to programme the LV-MSG command.To programme another command, keep pressing NEXT until the desired command isdisplayed.Display example: LV-MSG:H3. Enter a DTMF signal number.To delete the current entry, press CLEAR.To change the current entry, press CLEAR and enter the new number.4. Press STORE.5. To programme another selection, keep pressing NEXT or PREV until the desired selectionis displayed.6. Repeat steps 3 through 5.7. Press END.Conditions• A command signal number can have a maximum of 16 digits, consisting of 0 through 9, ,#, FLASH and PAUSE.• The FLASH button is available only for LV-MSG and GETMSG commands to store "H"which means "Home Position".• If "H" is stored for "LV-MSG", a mailbox number programmed in programme [609] VoiceMail Access Codes or an extension number will be sent to the VM port (Follow On IDfunction). If certain codes are required before and after the ID code, insert "H" between thecodes, as "aaaHbbb". If nothing is stored, it will operate as "H".• If " H" is stored for "GETMSG", a mailbox number programmed in programme[609] Voice Mail Access Codes or an extension number will be sent to the port succeedingthe " ".Features Guide ReferencesVoice Mail Integration for Inband
