4.1 Troubleshooting120 Installation Manual4.1.4 Using the Reset ButtonIf the PBX does not operate properly, use the Reset Button. Before using the Reset Button, trythe system feature again to confirm whether there definitely is a problem or not.Notes1. When the System Initialize Switch is set to the "NORMAL" position, pressing theReset Button causes the following:• Camp-on is cleared.• Calls on hold are terminated.• Calls on exclusive hold are terminated.• Calls in progress are terminated.• Call park is cleared.Other data stored in memory, except the above, are not cleared.2. When the System Clear Switch is set to the "SYSTEM INITIALIZE" position, you mustpress the Reset Button with caution, because all data stored in memory will becleared by the following operation: (1) pressing the Reset Button and then, (2) settingthe System Clear Switch to the "NORMAL" position while the RUN indicator isflashing (within approximately 10 s).Operation1. If the PBX does not operate properly:a. Make sure that the System Initialize Switch is set to the "NORMAL" position.b. Press the Reset Button.2. If the PBX still does not operate properly:a. Set the System Clear Switch to the "SYSTEM INITIALIZE" position.b. Press the Reset Button.c. Return the System Initialize Switch to the "NORMAL" position while the RUN indicatoris flashing (within approximately 10 s).NoteAs a result of Step 2, all the programmed data will be cleared.RUN IndicatorALARM Indicator Reset ButtonSystem Initialize Switch
