User ProgrammingUser Manual 473.1.2 Programming MethodsAdvancing to the next stageWhen "USR-PGM NO? " is displayed, you can select one of the following:• To go to program [000], press the NEXT button.• To go to another program, enter the 3-digit program address.Storing your dataPress STORE to store your data.• The STORE indicator lights red and a confirmation tone sounds.Making another selection within the same program address• To go to the next selection, press NEXT.• To go to the previous selection, press PREV.• To make a specific selection, press SELECT and then enter the number.Accessing another program addressa) While displaying the program address and title:• To go to the next Larger program address:Press the or MESSAGE button.• To go to the next Smaller program address:Press the or SECRET (INTERCOM) button.b) While programming:• To go to a specific program address:Press END, then enter the program address.Returning to the operation mode1. Lift the handset while in programming mode.2. When the Initial Message: USR-PGM NO? is displayed, press the PAUSE button.(To display the Initial Message, press END.)* Confirmation tone (one beep)After pressing STORE, you will hear a beep. This informs you that storage has beencompleted successfully.* Confirmation tone (two beeps)This informs you that the parameter has already been stored.* Alarm tone (three beeps)If you hear this alarm, your entry is not valid.
