Panasonic KX-T336 System Reference Manual

Also see for KX-T336: Installation instructions System reference manual Installation instructions Manual System reference manual

Contents

Panasonic KX-T336 System Reference Manual Manual pdf 1345 page image

12-C-18ResultOperation Comment/Note• This display is called “Initialdisplay for PITS-stationprogramming mode.”• If the following messageappears on the display, theprogramming data of your PITShas already been accessed byanother administration device.Already Accessed• From now on, in any status,pressing the END buttonrestores this status.• If nothing is entered within oneminute after dialing “01,” the“Initial display for PITS stationprogramming mode” is shownon the display again.• To change the assignment,simply dial the appropriatenumber again.1. Set the MEMORY switch atthe rear of PITS to“PROGRAM.”2. Dial “01.”3. To change the presetfeature, dial the programnumber corresponding to thedesired feature.• To set No Line Preference,dial “1.”• To set Ringing LinePreference, dial “2.”• The following messageappears on the display.PITS-PGM No.?• The MEMORY button indicatorlights in red.• Preset data appears on thedisplay.When “No Line Preference” ispreset:Pref. In : No• The following messageappears on the display:Pref. In : No.• The following messageappears on the display:Pref. In : RingSET• • PROGRAMMEMORYContinuedIf “No Line Preference-Answering” is selected, noline is connected to a PITS telephone by lifting thehandset or pressing the SP-PHONE button.For further information about this feature, refer toSection 4-D-1.00 “Line Selection-Answering.”The table shows the operation for eachprogramming. (The explanation of the messagedisplay applies only to a PITS provided with thedisplay.)5.00 Automatic AnsweringSelectionThis feature automatically connects a PITStelephone to a pre-assigned line when anextension user lifts the handset or press the SP-PHONE to answer incoming calls.There are two options by which an extension usermay select a desired line.• Ringing Line Preference-Answering (Default)• Prime Line Preference-Answering