Panasonic H-37PWD7UY Operating Instructions Manual

Panasonic H-37PWD7UY Operating Instructions Manual Manual pdf 10 page image

10PC Input Terminals connectionNotes:• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and verticalscanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 640 × 480 dots (TH-37PWD7UY, TH-42PWD7UY), 768 × 768 dots (TH-42PHD7UY),1,024 × 768 dots (TH-50PHD7UY) when the aspect mode is set to “NORMAL”, and 852 × 480 dots (TH-37PWD7UY, TH-42PWD7UY), 1,024 × 768 dots (TH-42PHD7UY), 1,366 × 768 dots (TH-50PHD7UY) when the aspect mode is set to“FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you willneed to make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.• Component Input is possible with the pin 1,2,3 of the D-sub 15P Connector.AUDIOPC INCOMPUTERConversion adapter(if necessary)RGBD-sub 15pStereo plugPC cableConnect a cable which matchesthe audio output terminal on the computer.Less than3" 15 /16(10 cm)Ferrite core (small size)(supplied)Ferrite core (large size)(supplied)AudioLess than3" 15 /16(10 cm)R - STANDBYG POWER ONINPUT MENU ENTER– +VOLInstalling the ferrite core (Small size)Pull back the tabs(in two places)OpenPress the cablethrough and close1 2 3Installing the ferrite core (Large size)Pull back the tabs(in two places)OpenPress the cablethrough and close1 2 316 7 8394 51015141312112Signal Names for D-sub 15P ConnectorPin Layout for PC Input TerminalPin No.12345Pin No.678910Pin No.1112131415Signal NameR (P R/C R)G(Y)B(PB/C B)GND (Ground)GND (Ground)Signal NameGND (Ground)GND (Ground)GND (Ground)NC (not connected)GND (Ground)Signal NameGND (Ground)SDAHD/SYNCVDSCLConnections