Panasonic GA-ML4TPoE+ Series Installation Manual

Also see for GA-ML16TPoE+: Manual Manual Installation guide Installation guide

Contents

Panasonic GA-ML4TPoE+ Series Installation Manual Manual pdf 17 page image

17Ports 1 to 4 support IEEE802.3at/af PoE. This function allows for power supply of up to 30 W througheach port and 62W in total through the Switching Hub. PoE power supply function operation overview2.2 PoE power supply functionPort LEDs (right) 1 to 4Green Light: Supplying power normally.Orange Blink: Overload caused by a single port. (Requested power is exceeding 30 W. *1) ortotal power supplied by the Switching Hub.Off: Not supplying power or no PoE-powered device connected.PoE LIM. LED (PoE limit)Off: Supplying power in the range from 0 to 47 W.Green Light: Supplying power in the range from 47 to 62 W.Orange Blink: A single port's power supply is exceeding the upper limit, or the total powersupply of the Switching Hub is exceeding 62 W.*1 When configured IEEE802.3at (factory default). Exceeds 15.4 W when configured IEEE802.3af.When the requested power supply for the Switching Hub is exceeded and it gets overloaded, thepower supply to the low priority ports is stopped, and the port LEDs (right) of the ports whose powersupply have been stopped blink orange.The priority settings for the power supply can be set and changed from the console, etc. Power supply while the PoE LIM. LED is blinking orange(overload caused by the total power supplied by the Switching Hub)When the power supply which is requested exceeds 30 W via a single port and the port LED (right)blinks orange, and the power supply is stopped.Unplug the port cable which is blinking orange, and check the PoE receiving equipment’s specifications.Caution: 1) Some PoE-powered devices may have a large difference in power consumption betweentheir maximum power use condition and normal condition. Carefully configure them sothat the upper limit of power supply will not be exceeded.2) If you do not set a priority for power supply or if the same priority is given, note that thepower supply priority is assigned to the ports in ascending order of the port numbers.(When the requested power supply exceeds 62W, power supply to a port with a higherport number will be stopped first.) Power supply while the overload is caused by a single port* For configuration and management method, please see the PDF version OperatingInstructions in CD-ROM.