Panasonic GA-ML4TPoE+ Series Installation Manual

Also see for GA-ML16TPoE+: Manual Manual Installation guide Installation guide

Contents

Panasonic GA-ML4TPoE+ Series Installation Manual Manual pdf 18 page image

Installation and Configuration1833.1 Grounding Cable ConnectionThe chassis of the equipment must be grounded properly so that the lightning can flow tothe ground, which improves the capability of the chassis for resisting the electromagneticinterference.1. Ensure that the grounding cable is connected correctly so that the equipment isprotected against lightning and interference. The correct connection of the groundingcable is an important measure to ensure the human safety.2. Connect the chassis to the ground by using a grounding cable. The grounding resistancemust be smaller than 0.10 ohms and the gauge of the grounding cable must be no lessthan 18 AWG and the length is 50 cm.3. The ground installed screw shall comply with 3.5mm minimum in nominal threaddiameter, and engage at least two complete threads into metal chassis with appropriatefixing hardware like washer.4. The grounding cable shall not be removed while normal operating, servicing ormaintenance.5. Installation steps:Step 1: Ensure the detachable power supply cord removed.Step 2: Use the screwdriver to turn the screws on the earth ground screw point.Step 3: Strip one end of the ground wire to the ground hole of system.Step 4: Connect the other end of the ground wire to a suitable grounding point ofbuilding at your side.Figure shows the grounding points.Back panelGreen/YellowGround cable1. 18 AWG min.2. 50 cmGrounding pointBuildingMains PowerSwitchearthterminal