Panasonic GA-ML4TPoE+ Series Installation Manual

Also see for GA-ML16TPoE+: Manual Manual Installation guide Installation guide

Contents

Panasonic GA-ML4TPoE+ Series Installation Manual Manual pdf 16 page image

16Part Names and Functions2Switch two types of Base modes and their LEDs in the following way:When Base mode is Status mode (factory default setting)When Base mode is ECO modeSwitch Base mode (keep pressing "LED DISPLAYCHANGE BUTTON" over 3 seconds)Press "LED DISPLAY CHANGE BUTTON" manually.AutomaticAutomatically returns to Base mode after 1 minute.Loop detection/shutoff function and loop history functionIf you wish to clear loop detection history, turn OFF once the power supply of theSwitching Hub and turn it ON again.Then, loop detection history is deleted.The Switching Hub can hold up to 64 loop history logs.BootStatus mode(Base mode) GIGA mode DUPLEXmodeLoop HistorymodePress "LED DISPLAY CHANGE BUTTON" manually.AutomaticAutomatically returns to Base mode after 1 minute.BootECO mode(Base mode)StatusmodeGIGAmodeDUPLEXmodeLoop historymodeThe Base mode is maintained even after the power is turned OFF.LED lamps for each mode and LED lamps for ports 1 to 6 correspond as shown in Table 1 (see page 14).Turns on the port LED with a orange light when a loop occurs in the corresponding port.The Loop shutoff mode has the following 2 types of modes.- Block mode (factory default)When loops are detected, the port statuses are automatically blocked, and just the specifiedpackets which include the loop detection packets will be transmitted and received.- Shut-down modeWhen loops are being detected, the ports will be automatically linked down, and none ofthe packets will be transmitted and received.*Just the loop detection packets from 30 seconds before the set restoration times willautomatically be transmitted and received.During loop is occurring, or if loop has occurred within the latest 3 days, LOOP HISTORYLED blinks to notify this. It is possible to switch loop detection setting (OFF/ON) by using aconsole cable (for detail, see the attached CD-ROM). The default setting is ON.