OPERATING INSTRUCTIONSWARNINGDo not disassemble the the fan heater formaintenance with a method which is not inthe instructions. Any maintenance otherthan user maintenance should be performedby specialized serviceman.Do not attempt to use the fan heater beforeit is completely and properly installed.Do not tamper with the fan heater.Use this fan heater only in the mannerintended by the manufacturer.If you have any questions, contact themanufacturer. Any other use notrecommended by the manufacturer maycause fire, electric shock, or injury topersons.See “MAINTENANCE” on pages 14-15 foruser maintenance.Please operate as shown in the following after installation. (Fig.16)Switching operating modes requires a slight delay to change the internal shutter positions.(The light mode and night light mode excluded.)Pick-A-Flow™ switch is not available to set ventilation air volume while operating in the heating andventilating mode. (Adequate ventilation air volume is provided to reduce heat loss in a bathroom)Timer functionExample 1The heat switch circuit will turn off in 2 hours if a user forgets to turn off the switch.If this happens, move the “Heat” or “Vent” switch back to the “OFF” position to reset thetimer function and resume operation according to the switch status.*Attach switch labels to the wallswitch as shown above. (Fig.16)Fig.16Switch labelsLight HeatVentFor ModelFV-0511VH1For ModelFV-0511VHL1Night-LightHeatVentEnglish 13Switch Mode Function“Heat” Heating Heating the bathroom“Vent” Ventilating Ventilating the bathroomBoth of“Heat”and“Vent”HeatingandVentilatingExhausting moisturewhile keeping thebathroom warm“Light” Light Turns on the main light“Night-Light” Night-Light Turns on the night lightModeSwitch2 hourslaterHeating Power offHeatVentExample 2HeatVentONOFFONOFF2 hourslaterHeatingandVentilating VentilatingHeatVentHeatVentONONONON*OPERATION