Panasonic FJ1202-1124 Operating Instructions Manual

Also see for CF-VCD281: Operating instructions

8ESoftware Preparation (first time only)To use the CD-ROM drive in the MS-DOS mode, configure the drive following the stepsbelow after performing the preparations ( page 6). If the steps listed below are per-formed without completing the preparations first, the drive will not operate properly.1 Select [Start] then select [Shut Down].2 Select [Restart in MS-DOS mode] and select [OK].3 Open the “CONFIG.SYS” file for editing by issuing the following commands:cd \ Enteredit config.sys Enter4 Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters“rem” at the beginning of the line. (Deleting “rem” causes the item to become valid.)DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000(If this line is missing, add it.)5 Press Alt + F , then S to save the file. Then press Alt + F , then X toexit the Edit program.6 Follow the same steps to edit the “AUTOEXEC.BAT” file.edit autoexec.bat Enter7 Move the cursor to the line containing “MSCDEX.EXE” and delete the characters “rem”at the beginning of the line. (Deleting “rem” causes the item to become valid.)LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L(If this line is missing, add it.)8 Press Alt + F , then S to save the file. Then press Alt + F , then X toexit the Edit program.9 Restart the computer.Using the Drive in the MS-DOS Mode Windows 98