- 13 -Cutting depth adjustment• Remove battery pack.• Loosen the depth adjustment nut and adjustthe cutting depth, using the graduations on thelower guard to gauge the depth. Once finishedadjusting the depth, tighten the depth adjust-ment nut securely.* When wood material is 10 mm (3/8") or lessthick, adjust the cutting depth so that the bladeprotrudes approx. mm (3/1") from the bottomof the material.DepthadjustmentnutPull downLoosenTightenFig. 9Rip fence (EY3500B7727)(Available as an accessory, not included)Rip fence is convenient for rip cuts and repeatedcuts of uniform width.• Remove battery pack.• Insert rip fence and adjust cutting width. (SeeFig. 10)• Fasten screw securely to fix rip fence.Insert andadjustFasten screwRip fenceFig. 10Collecting DustWARNING* Before cutting metal materials, always emptythe dust case, open the front cover andremove the dust.• Use the tool with the flammable materialsin the dust case to cut metal materials mayresult in fire* When cutting metal materials, always use thetool with the dust case attached.• Flying sparks and metal chips may causeinjury.* Do not carry or store the battery pack inthe same container as nails or similar metalobjects.(1) Collect dust in the dust case.* Empty the dust case when it is filled up withdust.* Empty the dust case before storing the tool.* Dust case capacity• When cutting electrical conduit with adiameter of mm (1"), approximately130 cuts• When cutting 4 mm (1-/3") x 4 mm(1-/3") lumber, approximately 10 cutsNOTE:Some materials may cause dust to becomeclogged inside the front cover when cuttingthose materials.Front coverFig. 11() Use with vacuum cleaner to collect dust.* Connect the tool to the hose using theEY9X01E vacuum cleaner hose adapter(sold separately).Compatible hose inner diameter: mm(1") to 38 mm (1-/1")* Operate the vacuum cleaner obeying itsinstructions.