Panasonic EY-6506 Operating Instructions Manual

Also see for EY-6506: Operating instructions

Contents

- 3 -Such preventive safety measuresreduce the risk of starting the tool acci-dentally.16) Store idle tools out of reach of chil-dren and other untrained persons.Tools are dangerous in the hands ofuntrained users.17) When battery pack is not in use, keepit away from other metal objectslike: paper clips, coins, keys, nails,screws, or other small metal objectsthat can make a connection from oneterminal to another.Shorting the battery terminals togethermay cause sparks, burns or a fire.18) Maintain tools with care. Keep cut-ting tools sharp and clean.Properly maintained tools with sharpcutting edge are less likely to bind andare easier to control.19) Check for misalignment or binding ofmoving parts, breakage of parts, andany other condition that may affectthe tool’s operations. If damaged,have the tool serviced before using.Many accidents are caused by poorlymaintained tools.20) Use only accessories that are recom-mended by the manufacturer for yourmodel.Accessories that may be suitable forone tool may create a risk of injury whenused on another tool.ServiceService21) Tool service must be performed onlyby qualified repair personnel.Service or maintenance performed byunqualified personnel may result in arisk of injury.22) When servicing a tool, use onlyidentical replacement parts. Followinstructions in the Maintenancesection of this manual.Use of unauthorized parts or failureto follow Maintenance Instructionsmay create a risk of shock or injury..SPECIFIC SAFETYSPECIFIC SAFETYRULESRULES1) Hold tool by insulated gripping sur-faces when performing an opera-tion where the cutting tool may con-tact hidden wiring.Contact with a “live” wire will also makeexposed metal parts of the tool “live”and shock the operator.2) Wear ear protectors when using thetool for extended periods.Prolonged exposure to high intensitynoise can cause hearing loss.3) Be aware that this tool is always in anoperating condition, it does not haveto be plugged into an electrical outlet.4) Do not operate the Forward/Reverselever when the Variable speed con-trol trigger is on.The battery will discharge rapidly anddamage to the unit may occur.5) If the bit becomes jammed, imme-diately turn the Variable speed con-trol trigger off to prevent an overloadwhich can damage the battery packor motor. Use reverse motion toloosen jammed bits.6) When storing or carrying the tool,set the Forward/Reverse lever to thecenter (switch lock) position.7) Do not strain the tool by holding thespeed control trigger halfway (speedcontrol mode) so that the motorstops.8) During charging, the charger maybecome slightly warm. This is nor-mal. Do not charge the battery for along period.Symbol MeaningV VoltsDirect Currentn0 no load speed…/min revolutions orreciprocation per minutesForward RotationReverse Rotation