Panasonic ET-RFE300 Operating Instructions Manual

Also see for ET-RFE300: Operating instructions

Contents

operating instructions

W1013GC1026 -STJ DisposalWhen discarding this product, please contact your local authorities or dealer and ask forthe correct method of disposal.Web Site : http://panasonic.net/avc/projector/© Panasonic Corporation 2013Panasonic Corporationz Perform Step 2) in the reverse order to close the air filter cover, and push in the air filtercover securely until it clicks into place.6) Connect the power plug, set the

switch to , and pressthe power button <v/b> on the control panel or on the remote control to turnon the power and start the projection.7) Press the button to display the main menu, then press as to select[PROJECTOR SETUP].8) Press the button.9) Press as to select [FILTER COUNTER].10) Press the button.z The [FILTER COUNTER] screen is displayed.11) Press as to select [FILTER COUNTER RESET].12) Press the button.z The [FILTER COUNTER RESET] screen is displayed.13) Press qw to select [OK], then press the button.z The filter usage time is reset.Attentionz Make sure that the air filter unit is properly attached before using the projector. If it is notattached, the projector will suck in dirt and dust causing a malfunction.z Dispose of the packaging materials properly after unpacking the product.z Do not disassemble the air filter unit.Notez If you use the projector without attaching the air filter unit, the filter indicator blinks in red and themessage appears on the projected image for about 30 seconds. Turn the projector off, and thenattach the air filter unit before turning the projector on again.z The replacement cycle of the air filter unit varies greatly depending on the usage environment.z For procedures on maintaining the air filter unit, refer to the operating instructions supplied withthe projector.Replacing the air filter unit (continued)

/ 4

Related manuals for Panasonic ET-RFE300