Panasonic ER147 Operating Instructions Manual

Also see for ER-147: Operating instructions

Before using the hairclipperThis clipper is designed forprofessional use to trim hair andbeards. Charge for 12 hours beforeusing the clippers for the first timein order to activate the built-inrechargeable battery. The clippercan be operated on either an ACpower source or a rechargeablebattery. Read all instructionscafefully before use.Parts identification® Blade©Attachment mounting©Head Block© Body©Indicator lamp©Switch© 5/8 "(15 mm) -11/16”(18mm)comb attachment®3/8”(9mm) -1/2”(12mm)comb attachment© 1/8”(3mm) '1/4”(6mm)comb attachment©Moving blade©Fixed blade©Lever for cleaning©AC adaptor (RE5-70)© Electric cord©Oil©Cleaning brushBefore useBefore using each time, apply theoil at the places marked with arrowsin Fig. 10.How to usecCharging instructions>1) Set the switch to “0-charge”, andplug the cord into the clipperbody. (Fig. 1)2) Plug the AC adaptor into an ACoutlet. The charging indicatorlamp will light up. (Fig. 2)3) When charging is completedunplug the AC adaptor from anAC outlet. The charging time is 4hours; 1 full charge will provideapproximately 60 minutes ofcontinuous operation.1) Connect the AC adaptor to thebody in the same way as forcharging, and set the switch to“1" to use the clipper.2) If the AC adaptor is connectedwhile the switch is in the “1”position, the clipper may notoperate. If this occurs, set theswitch to the “0-charge” position,wait about 1 minute and then setit back to the “1” position.3) Be sure to set the switch to“0-charge” when finished usingthe clipper. If the switch is left inthe “1” position, the rechargeablebattery will become completelydischarged, shortening the life ofthe battery.comb attachments>1) There are 3 comb attachments:one for 1/8” and 1/4”, one for 3/8”and 1/2”, and one for 5/8” and11/16”. The cutting heights are5