Panasonic ER1411 Operating Instructions Manual

Also see for ER1411: Operating instructions

4Charging the hair clipperCharge11 Slide the power switch to“0·CHARGE”.22 Plug in the AC adaptor into ahousehold outlet.33 Insert the appliance plug into theclipper.Charge status ( ) lamp glows in red and charging starts.Charging is completed when Charge status ( ) lamp blinks in redonce every second. (Max. 1 hour later)10 minutes after charging is completed, the charge status( ) lamp blinks in red once every seconds.1 full charge will provide approximately 80 minutes of continuousoperation.AC operationIf you connect the AC adaptor to the clipper in the same way as for charging,and turn on the power, you can use it even if the battery capacity is low.If the clipper does not operate, charge the clipper for approximately1 minute.Be careful not to discharge the battery completely with the power left turnedon. It results in shortening the battery life.••••••ER1411_AUS_JABARA.indd 4 2010/06/02 20:00:02