9 RQTC01529 RQTC0152 Connection/The remote control/QUICK SETUPCOAXIAL INAmplifier with a built-in decoder or adecoder-amplifier combinationCoaxial cableEnjoying surround soundSet “AUDIO OUT” to “OFF”( page 19, “HDMI” menu), and change“PCM OUTPUT”, “DOLBY DIGITAL” and“DTS” ( page 19, “AUDIO” menu).Connect the AC power supply cord lastConserving powerThis unit consumes a small amount of power, even when it is turned off (1 W). To savepower when the unit is not to be used for a long time, unplug it from the household ACoutlet.Batteries Insert so the poles (4 and 3) match those in the remotecontrol.Do not use rechargeable type batteries.Do not heat or expose to flame.Do not leave the batteries in an automobile exposed todirect sunlight for a long period of time with doors andwindows closed.Do not:mix old and new batteries.use different types at the same time.take apart or short circuit.•••••••To household AC outletAC INR6/LR6, AAattempt to recharge alkaline or manganese batteries.use batteries if the covering has been peeled off.Mishandling of batteries can cause electrolyte leakage whichcan damage items the fluid contacts and may cause a fire.Remove batteries if the remote control is not going to be usedfor a long period of time. Store in a cool, dark place.UseAim at the remote control sensor ( page 10), avoidingobstacles, at a maximum range of 7 m (23 feet) directly in frontof the unit.••You cannot use DTS Digital Surrounddecoders incompatible with DVD.•AC power supply cord (included)1Power onSelect2 3Follow the message andmake the settings.4Press to exit.RegisterTurn on the television and select the appropriate video input on the television.To change these settings later, select “QUICK SETUP” ( page 19, “OTHERS” menu).Shows QUICKSETUP screen.Back of the unitOKPress to finishQUICK SETUP.OK5STEP 2 The remote controlSTEP 3 QUICK SETUPRQTC0152-P(12.19).indd 9 2007-12-25 11:29:37