Panasonic DMR-EH55 Setup Manual

Also see for Diga DMR-EH55: Owner's manual Operating instructions Operating instructions Operating instructions

Panasonic DMR-EH55 Setup Manual Manual pdf 1 page image

DownloadingStep 3SettingStep 2ConnectionStep 1Turn the TV on.Switch input to "Video1" etc.e.g. the TV/VIDEO or INPUT buttonPreparing the TV On your TV'sremote controlTurn this unit on.Select the language.Select the type of TV you are using.Confirm the settings.Select,setSelect LanguageEnglishEspañolFrançaisSeleccione el idiomaSélection de LanguePress ENTERPulse ENTERAppuyer sur ENTERSelect,setSelect TV type and press ENTER.(Please refer to Operation Instructionfor details)Aspect Ratio Selection4:316:94:3 TV16:9 Widescreen TVENTERZIP Code -11111 (USA)Antenna on "RF"Are the above settings correct?NextBackYes, continue setup processNo, repeat setup process• If you make a mistake, press[RETURN].123457Select,setnext,Set Clock and Channels Automaticallyplease press ENTER.Connect antenna or Cable TV to RF IN.If you use a cable box, then tune it toyour local PBS channel, When done,ENTERSet Clock Manually1 / / :SAT AMMonth1Day2000Year12Hour00MinuteOffDSTESTTime ZoneENTER• Turn on the cable box or DirecTVreceiver if one is used.( Depending on the equipment that you connected,one of the following screens appears.)Finish the settings.A television reception screenor a blue background screenis displayed.8Start the TV Guide settings.TV Guide On Screen interactive program guideTV made easy.Built-in to this DVDRecorder!8 days of listingsPowerful show searchesOne-touch recordingsSubscription freeJust press ENTER on your remote to begin! START6 • Follow the on screen instructionsSelect “Next”and press [ENTER] togo to the next screen.Check the following again• The time is shown on the unit’s display.• Everything is connected correctly as shown in Step 1.Only when you are using a cable box or DirecTV receiver:• The cable box or DirecTV receiver is on.• The IR Blaster is located near the cable box or DirecTV receiver.• This unit features the TV Guide On Screen™ system thatprovides an 8-day grid of TV programs available in your area.• If you use the DISH Network service, you don’t need to wait todownload the program listings. Visit the following website.http://www.tvgos.com/support/echostar/(Program listings for satellite services other than DirecTVcannot be received.)Q : What is the TV Guide On Screen™ system?A : The TV Guide On Screen™ system provides a free, interactiveelectronic program guide (EPG) for checking what’s on. Settingup to record a program is easy too. Simply select the desiredprogram from the displayed listings.You can also search for desired programs by category, bykeyword, or alphabetically.In the United States, TV Guide, VCR Plus+, PlusCode, andother related marks are registered marks of Gemstar-TV GuideInternational, Inc. and/or one of its affiliates. In Canada, TV Guide,VCR Plus+, and PlusCode are registered marks of TranscontinentalInc., and are used under license by Gemstar-TV Guide International,Inc.Note• Leave the unit in standby mode when you are not using it. The unit will download the necessary data tomaintain the program listings while it is in standby mode. After turning the unit off, “BYE” appears briefl y on theunit's display. This shows the unit is in standby mode.• The fi rst few days of listings usually appear within 24 hours after a successful Setup. It may take up to six daysfor the full eight days of program listings to appear.Turn this unit offand wait for 24continuous hours!Press [TV GUIDE]and check theprogram listings.(After 24 hours)TODAYSCHEDULE LISTINGS SEARCH7:30PM 8:00PMSEARCH SETUP SCHEDULEVideo NotAvailableWelcometoTV GUIDE ON SCREENUsingTV GUIDE ON SCREENThe TV Guide On Screen system obtains channel andprogram information when your unit is turned off.When completed, the LISTINGS grid will display.Note: It may take up to 24 hours to start receiving listings.STEP STATUSsearch for timesearch for TV stationswith TV Guide datasearch for channel lineuplistings transmissionIn ProgressIn ProgressIn ProgressIn ProgressTV Guide On Screen Setup ProgressOK! If you have any questions contact(U.S.A.) www.panasonic.com/dvdhelp/1-800-211-PANA (7262)(Canada) www.panasonic.ca1-800-561-550512DVD Connection Guides (This is in English only) http://www.panasonic.com/consumer_electronics/dvd_recorder/dvd_connection.aspAV OUTRF IN AV INAV OUTRF INAV INAV OUTRF OUTRF INSatellite INRF IN1143 54756 832 2 9• Other connections (when you also want to record the televisionprograms with a VCR, etc.).Operating Instructions (P14 – 19).With a TV and VCR With a TV, VCR and cable box, DirecTV or DISH Network receiverSatellite antenna( Satellitereceiveronly)Cable from wall /antenna signalCable from wall /antenna signalYou must makethis connection.This unitCable box,DirecTV or DISHNetwork receiverTVTVThis unitVCR If your TV does not have AV terminals  If your TV does not have AV terminals(Instead of and ) (Instead of and )The IR Blaster is a device that allows this unitto communicate with the cable box or DirecTVreceiver. If you connect a cable box or a DirecTVreceiver to this unit, you also need to attach theIR Blaster.TVThis unitRF modulatorTVRF modulatorThis unitCable box orDirecTV receiver(the signal sensor)This unitConnecting and positioningthe IR BlasterIR BlasterIR Blaster: DVDPOWERbutton(in front of, and asnear as possible to,the signal sensor)Select,set: TV GUIDEbutton(Included)(Included)(Included)(Included)(Included)You must makethis connection.VCRGo to Step 2 Cable box, DirecTV orDISH Network receiver2 3 4 5Go to Step 2DirecTV/DISH Network service is only available in the United States and is notavailable or supported in Canada.• Before doing any connection, turn off all equipment (refer to theOperating Instructions of equipment for any operation).(Included)There is no need to connectthe IR Blaster, if you connecta DISH Network receiver.(Included)

/ 2

Related manuals for Panasonic Diga DMR-EH55