Panasonic DMR-EA38VK Operating Instructions Manual

Contents

26RQT9058Preparation:Turn on the unit and connected equipment.[RAM] If the disc is protected, release protection(¼ 47).[VHS] Ensure accidental erasure tab is intact.When recording multilingual broadcasts (¼ 21)DRIVESELECT to select the drive (DVD orVHS).Insert a disc or VHS cassette.REC MODEto select the recordingmode (¼ 22).INPUT SELECTIN1IN2DVOKInput Select123Recording from an External DeviceConnect cables while the power to both the unit and theexternal device is off.Front of the unitS VIDEOIN 2 VIDEO /MONO AUDIO RLYou can get asharper, clearerpicture by connectingwith an S Video cableinstead of the yellowvideo cable. Yellow White RedS Video cable Audio/videocable[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]Perform steps 1−5 left.Start play on an external device.RECto start recording theprogram from an external device.PAUSEto start recording theprogram from the external device.Perform steps 1−5 left.PLAYto locate the point on thetape where you want to insert therecording.PAUSEwhen you reach that point.RECto put the unit in recordingstandby.Start play on the external device.Recording to VHSRecording to DVDTipsTo skip unwanted partsPress [ PAUSE] to pause recording. (Press again to restartrecording.)To stop recordingPress [ STOP].,  to select “IN1” or “IN2”,then OK– If a program is recorded from a set top boxequipped with a Hard Drive, etc., connected toIN1 on the rear, then select “IN1”.– Front Panel inputs are IN2.NotesIf video is copied from another piece of equipment to this unit, thenthe video quality will be degraded.Recording from a VCR or a Set top boxequipped with a Hard Drive, etc. TipsIf the external equipment only has a single audio output, connect itto the L/MONO (white) IN2 terminal.