Panasonic DMR-E85HS Operating Instructions Manual

Also see for DIGA DMR-E85: Firmware instructions

Contents

21RQT7305 RecordingEntering PlusCode ® number is an easy way of timer recording. Youcan find them in TV listings in newspapers and magazines.≥You can enter up to 8 days in advance.≥VCR Plusi system works only after this unit downloads thetelevision program list (➡ page 10).1 Press [VCR Plusr].2 Press [3, 4] to select “PlusCode”.3 Press the numbered buttons to enterthe PlusCode number.≥To correct the numberPress [3] and press [4]. Enter the number again from thebeginning.4 Press [ENTER].Repeat steps 1–4 to program other recordings.≥As long as the setting is not changed, the program isrecorded to the HDD in the recording mode selected by theunit. To change the setting ➡ page 19, To change thesetting, step 3.5 Press [TV GUIDE].Returns to the television screen.≥The unit is not off. To save power, turn the unit off bypressing [Í DVD POWER].≥When using the cable TV box, make sure the cable TV box isturned on.∫ To cancel recording when recording has alreadybegunPress [∫], then [ENTER] within 5 seconds.≥You can also press and hold [∫] on the main unit for more than 3seconds to stop recording.Using VCR Plusi system to make timerrecordingsDate :Start Time :End Time :Channel :Quality :Destination :PlusCode :4 / 1 / 048 : 00 pm10 : 00 pm56SPHDD=========FAVORITESSat 2:00pm Dodzilla Once4/3 11:00pm NWBG OnceSat 3:00pm Bull house WeeklySat 3:30pm Be switched WeeklySat 4:00pm Baseball OnceLISTINGSMESSAGES SCHEDULERECORDREMOVE FREQUENCY INFO.87NWBGSPHDDRRRWRWR11:00 11:55Notes on timer recording≥“F” lights on the unit’s display to indicate that the unit is in timerrecording standby.≥“F” flashes when the unit cannot go to timer recording standby.≥Timer recordings are activated regardless of whether the unit isturned on/off.≥Timer recordings begin when the set time is reached evenwhen recording or when playing.≥Timer recordings do not begin while transferring (dubbing) innormal speed mode (➡ page 35).≥When you program successive timer recordings to startimmediately one after the other, the unit cannot record the partat the ending of the earlier program (approximately 15seconds). In addition, when recording to DVD-R, the unitcannot record the part at the beginning of the later program(approximately 15 seconds).≥If you set DST (Daylight Saving Time) to ON when manuallysetting the clock (➡ page 11), timer recording may not workwhen summer switches to winter and vice versa.∫ Relief RecordingWhen the recording drive is set to “DVD” for timer recording andif the program will not fit onto the disc, the recording drive will bechanged to the “HDD” automatically.≥If there is no disc in the tray or the disc cannot be recorded onor when timer recording starts while transferring (dubbing), therecording drive will be changed to the HDD.≥The Direct Navigator shows which programs were relief-recorded (“ ” is displayed.)(➡ page 24).≥If the time remaining on the HDD is insufficient, as much of theprogram as possible will be recorded onto the HDD.Program ProgramRecordedNot recordedRecordedNot recorded [DVD-R]