Panasonic DH-3MS1 Operating Instructions Manual

Main BodyThread EndShowerHoseRubberPackingFilter BodyAssemblyShower HeadParts notincludedUse flexiblepipe minimumlength 150 mmPlace Rubber Packing between Filter Body Assembly and Flexible Pipe.Do not use Piping Tape. Tighten it by Spanner firmly.Place Rubber Packing between Filter Body Assembly and Main Body.Do not use Piping Tape. Tighten it by hand firmly.Place Rubber Packing between Shower Hose and Main Body.Do not use Piping Tape. Tighten it by hand firmly.Place Rubber Packing between Shower Hose and Shower Head.Do not use Piping Tape. Tighten it by hand firmly.The Filter Body Assembly should be placed in the front direction of the Unit.5. Piping installation procedureDo not share the inlet or outlet pipe of HomeShower Unit with other outlets.The pressure may drop due to water beingdrawn off at other point. The shower watertemperature may become very hot.WARNINGAvoid using dirty water as it may affectheater performance and other components.CAUTIONMake sure no water leaks from pipe connection.NOTE:When glue is used for external piping connection, must waitfor the glue to dry before proceed to test run with water.NOTE:• The Unit must be earthed.• Earth Rod fixing procedure. Select suitable place to bury the optional Earth Rod (DQ-6H) for at least 70 cm below ground surface.• Ensure that the ground resistance is less than 100 Ω. If it is not, drive the Rod deeper into ground surface or use 2 or 3 Rods.Earth RodThe Unit must be earthed.Improper grounding could cause electric shock.WARNINGAbout 2 mAbout 2 mGroundSurface(Parallel Style)Earth Rod70 cm at least70 cm at leastConnectionBurying tool (Bevel Style) )70 cm at leastConnectionMake sure the Power Control Knob / Temperature Control Knob on Front Plateand it is at “Off” position.Make sure the Power Knob Cap slot and the D-Cut position of the VRShaft are located as shown (Off condition).Close the Front Plate of the Unit according to the sequence as illustrated.Push in the Power Control Knob / Temperature Control Knob until it is fullyinserted inserted if Step and Step is not done accordingly>Please ensure to rotate the Power Control Knob / Temperature ControlKnob clockwise until “High” and counter clockwise until “Off” to ensurethe knob is fully inserted to the Power Knob Cap slot inside.Fix the Screw at the bottom of the Unit.Note:1. Do not push the ELB Test Button during fixing the Front Plate.2. Do not apply extreme force to insert the Power Control Knob /Temperature Control Knob during fixing the Front Platebecause it will damage the switch inside the Unit.6. How to fix the Front Plate- 20 -FrontPlateBack PlatePressPressClockwiseCounterClockwise"D-Cut" positionof VR ShaftWater InletWater OutletFilter BodyAssemblyPower Control Knob /Temperature Control KnobScrewPower KnobCap slotL N