Panasonic DBS 576 Technical Manual

Also see for DBS 576: Technical manual Technical manual Technical manual User guide User guide

Contents

Panasonic DBS 576 Technical Manual Manual pdf 17 page image

Section 400: Programming Introduction to DBS 576 Programming576-20-400 DBS 576 (USA) issued January 1999 • Page Intro-7FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BAuto-Configuration (for single-cabinet systems only)This procedure will automatically configure a single-cabinet system for a selectableset of pre-defined settings (see table, next page).1. Set the CODE rotary switch to 1.2. Set the RAM HOLD switch to OFF.3. Hold in the MODE button on the CPC card,and either press the RESET button or power-on the system.• Wait for the MN LED to come on beforereleasing the MODE button.4. Move the RAM HOLD switch to ON.5. At an installed extension display phone, pressON/OFF. The phone should display:6. Dial the desired System ConfigurationPattern No. 1-6 (see table, next page).7. Press HOLD.8. Press ON/OFF.9. Wait for the initialize auto-configurationprocess to complete.Successful completion will be indicated bythe system returning to normal operatingmode (the main screen will appear on thephone):(front edge, facing out from cabinet)The CPC-96 CardRESET buttonCODE rotary switchMODE buttonRAM HOLD switchMOH plug-inRUN LED (MPU)MJ LEDMN LEDCN3(for PC Upgrade Kit)Pattern #:0Range : 1 - 6MSG CONF MENU PREV NEXT PROGFUNCTION EXTFUNCTION SYSTEMEXTENSIONSYSTEM DIALPERSONAL DIAL00:07 Wed JAN 01100 EXT100