Panasonic CZ-RWSU3U Operating Instructions Manual

Also see for CZ-RWSC3: Installation instructions Quick reference Operating instructions Operating instructions Quick reference

2. Names and Operations6(EN)REMOTE CONTROLLER One remote controller can control a group ofup to eight indoor units. (See page 15)1. Operation DisplayDisplays the operation status.(The figure shows all the possiblesegments that may appear on thedisplay.)• The auto-flap display may bedifferent depending on theinstalled unit. (See page 14.)2. Start/Stop buttonPressing this button once startsand pressing again stops theoperation.3. Fan speed button4. Swing/Wind Direction button5. Timer setting buttonUse for operating with a timer.6. RESET buttonUse this button after changing thebatteries.7. CoverPress at the top center and thenslide down.8. Transmitter9. Remote control sensorDetects the temperature at theremote controller when detectionhas been switched to the remotecontroller by the SENSOR button.10.Temperature setting buttonsraises the temperaturesetting.lowers the temperaturesetting.11. Filter buttonCZ-RWSC3Press to turn off the filter lamp onthe receiver.12.Mode Select buttonPress to switch the operationmode.13.Ventilation buttonUse this when connected to anaftermarket fan. Pressing thisbutton starts and stops the fan.When the air conditioner is startedor stopped, the fan starts or stopsat the same time. ( appears onthe display of the remotecontroller when the fan isoperating.)14.Address button15.SENSOR buttonUsed this to activate thetemperature sensor on the remotecontroller instead of the one onthe indoor unit.The temperature sensor on theindoor unit is selected atshipment. At this time is shownon the display.16.Clock buttonUse this to set the clock.From this page, the names ofremote controller’s buttons will beindicated with the aboveillustrations.E.g.: Start/Stop button 