Panasonic CX-DP880U User Manual

Also see for CX-DP880U - CD Changer: Operating instructions Operating instructions Operating instructions Service manual

Contents

Panasonic CX-DP880U User Manual Manual pdf 5 page image

HABCVHABCV1510ENGLISHCX-DP880U149ENGLISHCX-DP880UTypical horizontal installation HBCVA1 Mount a mounting bracket (L) or (R) on either sideof the control unit with a hex. bolt together withdouble washers (M4 x 8 mm).r Mounting bracket (L)t Mounting bracket (R)q Hex. bolt with doublewashers (M4 x 8 mm) x 4Typical vertical installationMount the unit with the mounting bracket on either sidewith a hex. bolt with double washers (M4 x 8 mm).r Mounting bracket (L) t Mountingbracket (R)q Hex. bolt with double washers(M4 x 8 mm) x 4HBCVA2 Select a location where the unit should be mounted.Fix the base brackets with a double-faced adhesivetape.w Base bracket x 2y Double-faced adhesive tape x 23 Use a cutter to cut a small cross in the carpet inaccordance with the locations of the M5 bolts of thebase brackets.w Base bracket x 2CarpetFix both the base brackets and the double-faced adhesivetape to a mounting surface below the carpet.HBCVA4 Mount the unit on the carpet with four hex. nuts(M5).e Hex. nut (M5) x 4CarpetRelationship between mountingholes and anglesThe relationship between mounting holes and angles ofthe mounting brackets (L and R) is illustrated above.Symbols corresponding to the mounting angles aremarked near the respective holes. Select the correct holesin accordance with the mounting angles to be used.Mounting bracket (L) Mounting bracket (R)RHBB AACCHVVBBAACCLHHVVInstallation LocationAvoid installing the unit in the following locations.¡In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.¡In an area where you cannot firmly secure the unit, or in high-vibration areas.¡In areas with high humidity or high dirt and dust levels.Horizontal:Vertical:Installation Angle Selecting a mounting angle(Normal) (Up-side down)Limit to less than 10 degrees.Limit to less than 10 degrees.HABCVSet the screw to the samepositions for both left and right.(Normal) (Up-side down)Limit toless than10 degrees.Do not tilt in thisdirection.Limit to less than10 degrees.Set the screw to the samepositions for both left and right.HABCVTypical horizontal installationTypical vertical installationInstallation (continued)Cautions:¡Set the angle-adjusting screw to the same angle as the unit is installed.¡Set the holes to the same positions for both left and right.Use a screwdriver to set the angle-adjusting screw to the position “V” or “H”,depending on the mounting angle selected.This unit can be set in the five directions: horizontal, vertical, and the positions A(22.5°), B (45°), and C (67.5°). Mount the unit by referring to the figures below.Select the mounting angleDefault: HAdjust the angle with a screw driverH (0°) V (90°)HABCVHCBAVHABCVHCBAVHABCVHCBAVHABCV VHCBA HABCVHCBAVA (22.5°)A (22.5°) B (45°)B (45°) C (67.5°)(L) (R) (L) (R) (L) (R) (L) (R) (L) (R)

/ 6

Related manuals for Panasonic CX-DP880U - CD Changer