Panasonic CQ-C3100AN Operating Instructions Manual

Contents

18 199ENGLISH10ENGLISHCQ-C3300/C3100A/C3100G/C3100VNCQ-C3300/C3100A/C3100G/C3100VNTraffic Announcement (TA)Some RDS FM stations periodically provide traffic information.Radio Data System (RDS) (continued)A FDISPHDBSPWRSOURCETA MUTECQ-C3300NSCROLLRANDOMSCANREPEATDISC /FOLDER1 2 3 4 5 6TUNETRACKOPENBANDAPMPTYREGVOLUMEPUSHSELTP (TA) Search (Default: OFF)While the unit is receiving a non-TP station or TP stationwith poor reception, the unit will seek a TP station withgood reception by pressing [TA] (TA mode) during recep-tion of an FM station. When the TP station received beginsa traffic announcement, you can hear it from the unit evenin the other modes (TA standby or CD or MP3/WMA) .TP Indicatorlights up during reception of TP station.TA Standby ModeBeing set to TA on in another mode, the unit will be auto-matically switched to the radio mode and make a trafficannouncement when it begins. The traffic announcementhaving finished, the unit will return to the previous mode.To listen to only trafficannouncementsWhile listening to an FM station which is not currentlybroadcasting traffic announcement, turn the [VOLUME]to the counterclockwise to set the volume to 0. The trafficannouncement will be output at the TA volume level.Other TA functionsTA Volume Set: Traffic announcements are broadcast atthe TA volume level. (a Page 32)TP Seek Tuning: When TA ON is selected, only TP sta-tion will be searched.Press and hold []] or [[] for more than 0.5 seconds,then release. Seeking will start.TP Auto Preset Memory: When TA ON is selected,only TP station will be memorized automatically. (a Page15 for auto preset memory)TP Auto Search: When reception of a TP stationbecomes poor, TP Auto Search will automatically searchfor a TP station with better reception.Program Type (PTY) ReceptionRDS FM stations provide a program type identification signal. (Example: news, rock, classical music, etc.)A FDISPHDBSPWRSOURCETA MUTECQ-C3300NSCROLLRANDOMSCANREPEATDISC /FOLDER1 2 3 4 5 6TUNETRACKOPENBANDAPMPTYREGVOLUMEPUSHSELDISPProgram Type (PTY) ModePress and hold [DISP] (PTY) for more than 2 seconds toswitch the PTY display mode on and off.The PTY function described below becomes enabled afterselecting to the PTY mode.PTY Selectionq Press [[] to change the program type as shown below.([]]: opposite direction)w Select the desired program type and press [BAND].Search will start to tune in to a station broadcasting theselected program type.Press [BAND] again to cancel.Note:¡ When there is no corresponding program type station,“NONE” is displayed for 2 seconds.PTY PresetPTY Preset CallProgram types are stored in memory under preset buttonsfrom [1] to [6] as shown in the tables on the next page.To tune in the desired program type, press any of presetbuttons from [1] to [6].Preset PTY Searchq Select a program type by pressing the preset button.The preset program type appears on the display for 5seconds.Example: Press preset button [1].w Press the same preset button again (or press [BAND])to tune in the desired program type station.Example: Press preset button [1] again.Press [BAND] again to cancel.Note:¡ When there is no corresponding program type station,“NONE” is displayed for 2 seconds.PTY Preset Changeq Select a program type by using PTY Selection or press-ing PTY Preset buttons.w Press and hold one of the buttons from [1] to [6] formore than 2 seconds.Example: Press and hold preset button [2] for morethan 2 seconds.SPEECH / MUSIC / NEWS / AFFAIRS /INFO / SPORT / EDUCATE / DRAMA /CULTURE / SCIENCE / VARIED / POP_M /ROCK_M / EASY_M / LIGHT_M / CLASSICS /OTHER_M / WEATHER/ FINANCE / CHILDREN /SOCIAL / RELIGION / PHONE_IN / TRAVEL /LEISURE / JAZZ / COUNTRY / NATION_M /OLDIES / FOLK_M / DOCUMENT[TA] (TP (TA) Search)[]] [[](TP seek tuning)[DISP] (PTY)(PTY mode)[]] [[](PTY selection)[BAND] (Preset PTY search, PTY selection)Preset Buttons [1] to [6] (PTY preset)[VOLUME] indicator indicator indicator