Panasonic CM602-L Reference Manual

CM602-LReference Manual1.4 Other SpecificationsPage 1-181.4.2 Installable Feeder Count1. Intelligent feeder Feed pitch (1 pitch = 4 mm)FeedertypeTapewidthType Reeldiameter∗1InstallationpitchMax.depth ofbossMaxinst.reel count 0.5 1 2 3 4 5 6 7 8 9 10 11 12 13 14Small 21 mm 2168 mm∗2double T/F 8 mm PaperEmbossed Large 21 mm 3 108 z zSmall 21 mm8 mmsingle T/F 8 mm PaperEmbossed Large 21 mm 3 108 z zSmall 21 mm 15 10812 mm Embossed Large 21 mm 15 10812 mm16 mmshared T/F 16 mm Embossed Large 21 mm 15 108∗3 z z z z24 mm Embossed Large 42 mm 15 5224 mm32 mmshared T/F 32 mm Embossed Large 42 mm 15 52z z z z z z z z1544 mm Embossed Large 63 mm 21∗5 361544 mm56 mmshared T/F56 mm Embossed Large 63 mm 21∗5 36z z z z z z z z z z z z z1572 mm T/F 72 mm Embossed Large 84 mm 21∗5 24 z z z z z z z z z z z z z88 mm T/F∗4 88 mm Embossed Large 105 mm 21∗5 20 z z z z z z z z z z z z z104 mm T/F∗4 104 mm Embossed Large 126 mm 21∗5 16 z z z z z z z z z z z z z32 mmadhesiveT/F∗6∗7 32 mm Adhesive Large 63 mm 2.8 36 3 (12 mm)∗1 :Reel diameter: Small reel =φ 178 mm, Large reel =φ 178 mm toφ 382 mm∗2 :For the 8 mm double tape feeder, two small reels or each one of small and large reels can be set.∗3 :Depending on the reel width, the maximum installation count may decrease.∗4 :The 88 mm and 104 mm types are always equipped with a joint detection sensor.∗5 :To use the maximum depth of boss (21 mm), the 21 mm thickness-ready cutting unit (option) and the 21mm cutting-ready changing truck (option) are required.∗6 :The adhesive tape feeder is always equipped with no joint detection sensor.∗7 :To use the adhesive tape feeder, the machine needs as many optional bulk/adhesive feeder-support units(1 set/1 table) as required.NOTICEThe following conditions are necessary for using the gang feed function in right andleft lanes of double tape feeder, for the high-speed head (12 nozzles).• Software incorporated in the double tape feeder: Version 5.00 or later• Software incorporated in the collectively changing truck: Version 1.20 or laterEJM4A-E-RMA01-A01-01