CF-VCCP11UConnector ProtectorOPERATING INSTRUCTIONSSS0103-0DFQX5377ZA© Matsushita Electric Industrial Co., Ltd. 2003Printed in JapanOPERATING INSTRUCTIONSThank you for purchasing the Connector Protector for thePanasonic CF-P1 handheld computer series.For details on how to use the CF-P1, refer to the OperatingInstructions accompanying the CF-P1.Names of the partsConnector Cover LockRelease LeverConnector CoverAnchoring HookConnection Procedure1 Refer to step 2 above, and open the connector cover.2 While pushing down the release button of the cable connec-tor, disconnect the connector.3 While pulling the release lever toward you, disconnect theconnector protector.Disconnection Procedure3 Run the cable along thegroove in the connectorcover, and close theconnector cover.1 Snag the anchoringhook in the computerísgroove in the sequenceof and .Ensure that the hookturns around , andsnag .2 Connect the cableconnector to the CF-P1.Turn (A) shown in thefigure right around itsaxis, and open the con-nector cover.Check the direction ofthe connector, and pushit into place until it issecurely anchored.4 Push the connectorcover firmly intoplace until theconnector coverlock engages withthe connectorcover.(A)○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○Do not pull the release lever while the cable connector isstill connected. The cable may be damaged.CAUTIONPrecautionsWhen performing the cable connections between the CF-P1 and a peripheral device using the connector protector,make sure that you follow the procedure described in thisOperating Instructions.When planning to carry the CF-P1 around with you, holdthe CF-P1 part (and not the connector protector).Be sure to read the ìPrecautionsî in the Operating Instruc-tions accompanying the CF-P1.Be sure to read the operating instructions of the peripheraldevice to which you are going to connect to the CF-P1.®