Panasonic CF-74 Series Supplementary Instructions Manual

Also see for CF-51 Series: Operating instructions User manual Operating instructions Operating instructions Operating instructions

Contents

Panasonic CF-74 Series Supplementary Instructions Manual Manual pdf 8 page image

8E1 Register the Supervisor Password.You have to register the Supervisor Password to proceed to the next step.If you have already registered the Supervisor Password, you can skip thisstep, and move on to step 2.If you have not done this, have enrolled your fingerprint using Protector SuiteQL, and have already made Power-on Security effective, after step B, yourfingerprint authentication will be necessary.A Turn on or restart the computer.B Press F2 several times while [Panasonic] boot screen is displayed soonafter the computer starts the startup procedure.C Select the [Security] menu.D Select [Set Supervisor Password], and press Enter .E Enter your password in the [Enter New Password], and press Enter .· The password will not be displayed on the screen.· You can use up to 32 alphanumeric characters (including spaces).· The case (upper/lower) is ignored.· To input numbers for the password, use the numbered keys on the keyboard.· You cannot use Shift and Ctrl to input a password.F Enter your password again in [Confirm New Password], and press Enter .G In [Setup Notice], press Enter .2 Set the High Security Level.A Select [Fingerprint Security Sub-Menu], and press Enter .B Select [Security mode:], and select [High].· Default setting: SimpleC Press ESC to close the sub-menu.D Press F10 , select [Yes], and press Enter to exit the Setup Utility.In the “High” security mode, you have to enter the Supervisor or UserPassword even after fingerprint authentication.In the “Simple” security mode, you do not have to enter the Supervisor orUser password after fingerprint authentication.NOTEMore Advanced SecurityYou can increase your computer’s security level by setting the BIOS level describedin this section.Performed by the Computer Administrator.