3 Getting StartedRead Me FirstModels for U.S.A.Federal Communications Commission Radio FrequencyInterference StatementNote: This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential instal-lation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordancewith the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interfer-ence will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by oneor more of the following measures:z Reorient or relocate the receiving antenna.z Increase the separation between the equipment and receiver.z Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.z Consult the Panasonic Service Center or an experiencedradio/TV technician for help.WarningTo assure continued compliance, use only shielded interfacecables when connecting to a computer or peripheral. Also, anychanges or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority tooperate this equipment.This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, includinginterference that may cause undesired operation.FCC RF Exposure Warning:z This equipment is provided with PC Card slot that could beused with wireless transmitters, which will be specificallyrecommended when they become available.Other third-party wireless transmitters have not been RFexposure evaluated for use with this computer and may notcomply with FCC RF exposure requirements.z This equipment complies with FCC radiation exposure limitsset forth for an uncontrolled environment.z This equipment has been approved for portable operation,and does not require any minimum spacing be providedbetween antennas and all person’s body.z This equipment may not be co-located or operated with anyother antenna or transmitter.25-M-3z This PC with WWAN transmitter installed, has been ap-proved for mobile operation and to assure compliance withRF exposure requirements, a minimum of 20 cm (8 inches)must be maintained between the WWAN antenna located intop of LCD and all person’s body (excluding extremities ofhands, wrist and feet) during wireless modes of operation.z This equipment is provided with external antennaconnector(s) for connection to optional Car Mounter or PortReplicator for mobile external mounted antenna(s).External antenna(s) must be professionally installed andcannot exceed recommended maximum antenna gain asdescribed in individual provided supplement instructions forwireless transmitters.For WLAN, the Car Mounter should be used with Radi-all/Larsen WLAN whip antenna, type NMO5E2400BKTNCwith 5dBi antenna gain or less. Also, user must maintainminimum 20 cm spacing between external antenna(s) andall person’s body (excluding extremities of hands, wrist andfeet) during wireless modes of operation.25-M-5This product is restricted to indoor use due to its operation inthe 5.15 to 5.25 GHz frequency range.FCC requires this product to be used indoors for the frequencyrange 5.15 to 5.25 GHz to reduce the potential for harmfulinterference to co-channel Mobile Satellite systems. High powerradars are allocated as primary users of the 5.25 to 5.35 GHzand 5.65 to 5.85 GHz bands. These radar stations can causeinterference with and/or damage this product.25-M-W-5Responsible Party: Panasonic Corporation of North AmericaOne Panasonic WaySecaucus, NJ 07094Tel No:1-800-LAPTOP5 (1-800-527-8675)6-M-1FCC Regulation Notice for modemThis equipment contains a FCC approved modem.1. This equipment complies with CFR47 Part 68 rules.On the computer is a label that contains, among other infor-mation, the FCC registration number and ringer equivalencenumber (REN) for this equipment. If required, this informa-tion must be provided to the telephone company.2. An FCC compliant telephone cord and modular plug isprovided with this equipment. This equipment is designed tobe connected to the telephone network or premises wiringusing a compatible modular jack which is Part 68 compliant.See Installation Instructions for details.3. The REN is used to determine the quantity of devices whichmay be connected to the telephone line. Excessive RENs onthe telephone line may result in the devices not ringing in re-sponse to an incoming call. In most, but not all area, the sum ofRENs should not exceed five (5.0). To be certain of the numberof devices that may be connected to a line, as determined bythe total RENs, contact the local telephone company.4. If your telephone equipment cause harm to the telephone network,the telephone company will notify you in advice that temporarydiscontinuance of service may be required. But if advice noticeisn’t practical, the telephone company will notify the customer assoon as possible. Also, you will be advised of your right to file acomplaint with the FCC if you believe it is necessary.5. The telephone company may take changes in its facilities, equip-ment, operations or procedures that could affect the operationof the equipment. If this happens the telephone company willprovide advance notice in order for you to make necessary modi-fications to maintain uninterrupted service.6. If trouble is experienced with this equipment, for repair orwarranty information, please contact Panasonic Corpora-tion of North America at DIAL TOLL FREE 1-800-LAPTOP5(1-800-527-8675). If the equipment is causing harm to thetelephone network, the telephone company may request thatyou disconnect the equipment until the problem is resolved.7. There are no user serviceable parts contained in this equipment.8. This equipment may not be used on coin service provided by the tele-phone company. Connection to party lines is subject to state tariffs.9. The Telephone Consumer Protection Act of 1991 makes it unlawfulfor any person to use a computer or other electronic device to sendany message via a telephone fax machine unless such messageclearly contains in a margin at the top or bottom of each transmit-ted page or on the first page of the transmission, the date and timeit is sent and an identification of the business or other entry, orother individual sending the message and the telephone number ofthe sending machine or such business, other entity, or individual. Inorder to program this information into your fax software, you shouldrefer to the manual of the Fax software being used.
