Panasonic CF-19 Operating Instructions Manual

Also see for CF-19 series: Supplementary instructions Operating instructions Operating instructions Supplementary guide Operating instructions

Contents

Panasonic CF-19 Operating Instructions Manual Manual pdf 14 page image

14Useful InformationInstalling software will return the computer to the default condition. When you install the software, the hard disk datawill be erased.Back up important data to other media or an external hard disk before installation.CAUTIONl Do not delete the Recovery Partition on the hard disk. The disk space in the partition is not available to store data.To check the Recovery Partition, perform the following methods.ARight-click at the bottom left corner of the Desktop screen.Click (Start) and right-click [Computer], then click [Manage].l A standard user needs to enter an administrator password.B Click [Disk Management].n Remove everything and reinstall WindowsPreparationl Remove all peripherals.l Connect the AC adaptor and do not remove it until installation is complete.1 Perform “Remove everything and reinstall Windows”.A Display “Charm” and click - [Change PC settings] - [Update and recovery] - [Recovery].B Click [Get Started] under “Remove everything and reinstall Windows”.C Click [Next].D Select the option.l Just remove my filesPerform the reinstallation of the Windows in a few moments (Approximately 20 minutes).l Fully clean the driveBy fully cleaning, the deleted files can not be recovered easily and the security level will be increased.The processing time will be longer (Approximately 140 minutes).Follow the on-screen instructions.After the reinstallation, the computer will restart.l Do not interrupt installation, for example by turning off the computer or performing other operation.Otherwise installation may become unavailable as Windows may not start up or the data may be corrupted.2 Perform the “First-time Operation” (è page 9).NOTEl The date and time, and the time zone may not be correct. Be sure to set them correctly.3 Perform Windows Update.4 Clear TPM.A Perform either of the following procedures.l Right-click at the bottom left corner of the Desktop screen.l Click on the Start screen.B Click [Run], then input [tpm.msc] and click [OK].C Click [Clear TPM…] under “Actions” on the right of the “TPM Manager on Local Computer” screen.D Click [Restart] of the “Manage the TPM security hardware” screen.The computer will restart.E When “TPM configuration change was requested to ...” is displayed, press F12 .F Click the Desktop tile, and when “TPM is ready” appears, click [Close].Installing Software