Panasonic Bread Bakery SD-250 Operating Instructions & Recipes

Also see for Bread Bakery SD-250: Operating instructions & recipes Operating instructions and recipes Operating instructions and recipes

TEMPALERTReason/CauseConditionMotor protection deviceRemedy 2There has been a 10-minute orless power cut. (The power plughas been inadvertently pulled out orthe breaker has activated.)How to reset/restartIf the interruption in the power supply ismomentary, the operation will not be affected.If the power is restored within 10 minutes, thebread maker will operate again. However, thebread may not turn out well.Remove the dough and start again using allnew ingredients.Not baked at all, althoughthe operation appears tohave proceeded.Check to see if the kneader mounting shaft canrotate.Motor protection device has activated.This only happens when the unit isoverloaded and an excessive forceis applied to the motor.After about 30 minutes, the motorautomatically starts running again.If the unit is overloaded and an excessive force is applied to the motor, the protection device willstop the motor. After approximately 30 minutes, the motor will automatically start running again. It isrecommended to restart with fresh ingredients.If the kneading blade is restricted by hard dough, take out the dough. Theunit will restart 30 minutes later.Check to see if the kneader mounting shaft of the bread pan can rotate.If it can rotate, restart the bread maker after 30 minutes. If it cannot rotate,service will be required.Make sure you did not usetoo much or too hard/heavyingredients, then start againusing all new ingredients.Service willbe required.is ondisplay.is ondisplay.appearsondisplay.There has been more than 10minutes power cut. (power failure,unplugging of the power cord, or amalfunctioning of household fuse orbreaker).Leave the unit as it is.When the unit has cooled to below 40ûC,will disappear from the display windowand the red indicating light will go out.This indicates that the unit is now ready to use.The unit is hot (above 40ûC).This may occur during repetitive use.You must allow the unit to cool downbefore reusing.ALERTTEMPTEMPDisplay Indications for Abnormal ConditionsYes No- 14 -Remedy 1