Rotating BladePress the switch and place the Ice Cream Maker in the freezer.Be sure to check that the indicator lamp is on.The Indicator lamp identificationSlow flashOperating normally (stirring for the first 5 seconds,stopping, and then selectively stirring and stoppingaccording to the program)Cooling before finishing (for approx. 60 minutes of operation)Abnormal condition (impossible to stir)Weak batteriesStandby or finished6Lights upFix the body to the container6Line up the position mark on the cover with the placement guide on the container.Set the side locks on both sides. Placement GuideRotating BladePosition MarkContainerSide LockCoverPosition the rotating shaft and the cover and then fix the rotating blade from the reverse side of the cover.78Quick flash (light is out after 5 seconds)Quick flash (continuous)Goes offDo not rotate the rotating blade by hand with force. It may cause damage to the bladeor motorPlease refer to P.10 "Troubleshooting" and fix.Press the switch again to stop the operation once the indicator lamp is lit.Place the Ice Cream Maker so that the container is flat in the freezer.You can not make ice cream while the indicator lamp is off.