Panasonic AW-RP501 Operating Instructions Manual

Also see for AWRP501 - HYBRID CONTROL PANEL: Operating instructions Service manual

Contents

Panasonic AW-RP501 Operating Instructions Manual Manual pdf 18 page image

-16-%2 Zoom/Focus Exchange Switch(ZOOM/FOCUS EXCHANGE, ON/OFF]ZOOM Lever #6 and FOCUS Lever #7 exchange theirfunction between them when this switch is set to theON position. Unless this exchange is needed, keepthe switch in the OFF position.With ZOOM/FOCUS EXCHANGE Switch %2 in the ONposition, the operations shown on the panel do notagree with the indications on the panel. In this case,paste the supplied seal on the panel.%3 Focus Reverse Switch[FOCUS REVERSE, NOR/REV]Changes the operating direction of FOCUS Lever #7.The lens is focused far when FOCUS Lever #7 ismoved toward FAR, or near when the lever is movedtoward NEAR, provided that FOCUS REVERSE Switch%3 is in the NOR position. When FOCUS REVERSESwitch %3 is set to the REV position, the lens focusoperates in the opposite direction.With FOCUS REVERSE Switch %3 in the REV position,the operating directions shown on the panel are oppo-site to the indications on the panel. In this case, pastethe supplied seal on the panel.%4 Tilt Reverse Switch [TILT REVERSE, NOR/REV]Changes the tilt direction controlled by PAN/TILT Lever#8. The pan/tilt head turns up when PAN/TILT Lever #8is moved toward UP, or down when it is moved towardDOWN, provided that TILT REVERSE Switch %4 is inthe NOR position. The pan/tilt head moves in theopposite direction if the TILT REVERSE Switch %4 is inthe REV position.With TILT REVERSE Switch %4 in the REV position, theoperating directions shown on the panel are oppositeto the indications on the panel. In this case, paste thesupplied seal on the panel.%5 Pan Reverse Switch [PAN REVERSE, NOR/REV]Changes the pan direction controlled by PAN/TILTLever #8. The pan/tilt head turns leftward whenPAN/TILT Lever #8 is moved toward LEFT, or rightwardif it moved toward RIGHT. The rotary head turns in theopposite direction if the PAN REVERSE Switch %5 is inthe REV position, provided that PAN REVERSE Switch%5 is in the NOR position. When PAN REVERSE Switch%55 is set to the REV position, the pan/tilt head turns inthe opposite directions.With PAN REVERSE Switch %5 in the REV position, theoperating directions shown on the panel are oppositeto the indications on the panel. In this case, paste thesupplied seal on the panel.Note: TILT REVERSE Switch %4 and PAN REVERSESwitch %5 may be used to reverse the operatingdirection of the pan/tilt head, but be sure to set theoperating direction of the pan/tilt head with itsmounting direction selection switch during itsinstallation depending on whether the pan/tilt headis mounted on the floor or is suspended. Unlessthe mounting direction selection switch on the