Panasonic AW-RP501 Operating Instructions Manual

Also see for AWRP501 - HYBRID CONTROL PANEL: Operating instructions Service manual

Contents

Panasonic AW-RP501 Operating Instructions Manual Manual pdf 15 page image

-13-1 +5V2 ZOOM3 FOCUS4 TILT5 PAN6 GND7 SPEED8 IRISGround GND123467Ground58Example of auxillarycontrol circuitNote: Make sure that the lens and pan/tilt head stopat the center point of the zoom, focus, pan and tilt controls(or at the lever reset position if the controls have a lever reset function).Iris controlZoomcontrol PancontrolTiltcontrolFocuscontrolSPEED switch100Ω 10KΩ10KΩ10KΩ10KΩ6.8KΩ20KΩ6.8KΩ100Ω100Ω100Ω8-pin DIN connectorpin assignment(as viewed from therear of the control panel)$3 VIDEO InputT Connector[TO CAMERA PAN/TILT HEAD, VIDEO IN](BNC Connector)Connect it to the video output connector [VIDEO OUT]on the pan/tilt head with a coaxial cable (5C-2V orequivalent), which may be extended up to 500 meters.$4 Genlock Output Connector[TO CAMERA PAN/TILT HEAD, G/L OUT](BNC Connector)Connect it to the G/L input connector [G/L IN] on thepan/tilt head with a coaxial cable (5C-2V or equivalent)in operating the camera in external sync mode. Thecable can be extended up to 500 meters.$5 Camera Control Output Connector[TO CAMERA, PAN/TILT HEAD CAMERA CONTROLOUT] (BNC Connector)Connect it to camera control input connector [CAM-ERA CONTROL IN] on the pan/tilt head with a coaxialcable (5C-2V or equivalent), which may be extendedup to 500 meters.$6 Pan/tilt Control Output Connector[TO CAMERA PAN/TILT HEAD, PAN/TILT CONTROLOUT] (RJ-45 8-pin Modular Jack)Connect it to pan/tilt control output connector [P/TCONTROL IN] on the pan/tilt head with a 10BASE-Tstraight cable (UTP category 5 or equivalent), whichmay be extended up to 500 meters.