Panasonic AW-HS50N Operating Instructions Manual

Also see for AW-HS50N: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

Panasonic AW-HS50N Operating Instructions Manual Manual pdf 62 page image

626. System settings6-1. System menu settings6-1-1. Setting the video formatThe video format of the entire system to which the unit isconnected can be set.(QTOCV K*K4GU/8 1HH53 1HH#7:#PEK 1HH2)/#PEK 1HH289#PEK 1HH/8#PEK 1HH+PKVKCN 1HH+2#FFTGUU 5WDPGV/CUM )CVGYC[ /#%#FFTGUU=?5;56'//GPWThe [14] SYSTEM Menu settings cannot be changed if“Locked” has been set using the menu item below.[13] Operation Menu14. SYSTEM MenuNote[14] SYSTEM Menu1. FormatSelect the supported format from among the optionsprovided below.Supported formats1080/59.94i 1080/50i720/59.94p 720/50p1080/24psf 1080/23.98psf480/59.94i 576/50i< How to specify the video format and then startthe system>With the unit in the power-off status, the video format can bespecified and the system started.Set the POWER switch to ON while holding down onecombination of the buttons listed below that corresponds tothe video format.Button to press at the same time Video format[OSD ON] + A bus crosspoint [1] 1080/59.94i[OSD ON] + A bus crosspoint [2] 1080/50i[OSD ON] + A bus crosspoint [3] 720/59.94p[OSD ON] + A bus crosspoint [4] 720/50p[OSD ON] + A bus crosspoint [5] 1080/24psf[OSD ON] + B bus crosspoint [1] 1080/23.98psf[OSD ON] + B bus crosspoint [2] 480/59.94i[OSD ON] + B bus crosspoint [3] 576/50i After the POWER switch has been set to ON, keepholding down the buttons until an image is output.[14] SYSTEM Menu2. HiResMVThis is used to decide whether to set the high-resolutionmulti view mode. When SD has been selected as thesystem’s video format setting, images can be output at highresolution as the DVI-D output.If this is the case, the multi view display is set for the DVIOUT connector output.The multi view display cannot be set for the SDI OUTconnector output.On: The high-resolution multi view mode is enabled.Off: The high-resolution multi view mode is disabled.[14] SYSTEM Menu3. 16:9SQThis is used to set the 16:9 squeeze mode.It can be set when SD has been selected as the system’svideo format setting.When the 16:9 squeeze mode is selected, SD formatimages are provided with a border width that factors incases where the images are to be converted into the 16:9aspect ratio.< Border width (graphical representation) when thesqueeze mode is supported>Squeeze (4:3) 16:9