Panasonic AV-HSB300G Operating Instructions Manual

Contents

Panasonic AV-HSB300G Operating Instructions Manual Manual pdf 7 page image

6 (E)ENGLISHMounting7 Install the board securely using the screws (B)and 3 screws (C).(At this stage, install the cable clamp as well.)Screws (B)Screws (C)Cable clamp8 Tighten the 6 screws (A) for the upper panelcover securely.Screws (A)9 After attaching the required cables, insert the power connector and turn the power on.For details on the setting and operating procedures, refer to the operating instructions of the AV-HS300G.If the HD analog board has been connected properly, “ANLG” will appear at the OPT item on theAV-HS300G ’s SETUP/STATS menu (5/5).STATS15/15 ALMNO OPTANLG VER1.00In order for the analog HD component signals to take effect, select “ANLG” (analog HD component) in theMODE item setting for each of the input channels (IN to IN5) from the AV-HS300G ’s SETUP/IN-5 menu(/5). Analog HD component signals and SDI signals cannot be used at the same time in the same inputchannel.Additionally, the gain of the input signals is set using the GAIN item.(The gain can be set within the30-step range, and the setting will result in changes of  dB. The amount by which the gain changes perstep is not the same for each step.)SDIIN2IN3IN4IN5IN1-51/15 SIGIN1 MODEANLG GAIN-30—30-Removal procedureRemove the HD analog board by following the procedures for mounting it in reverse.

/ 9

Related manuals for Panasonic AVHSB300G - HD ANALOG BOARD