Panasonic AJ-YA120AG Operating Instructions Manual

Panasonic AJ-YA120AG Operating Instructions Manual Manual pdf 43 page image

43Setup menus603 V-MUTE SEL0000000100020003N MUTEGRAYBLACKNOISEFor setting whether to mute the video output signal when a blank part of the tape isdetected during playback.0: The video output signal is not muted. (It is frozen.)1: The video output signal is muted and turned gray.2: The video output signal is muted and turned black.3: The video output signal is muted and turned into noise.600 VIDEO IN SEL000000010002INTSGHDSDI1394For selecting the video signals to be input.0: The internal signal selected by VIDEO INT SG is generated.1: The serial video signal supplied to the HD SDI IN connector is selected.2: The compressed digital signals supplied to the DV connector are selected.When this happens, the audio input signals will also be supplied from the DVconnector (digital video interface).O This item’s setting cannot be changed while a tape is being played back.O When 1394 is selected as this item’s setting, “1080i” is selected as the menuitem No.630 [1080i>HD_OUT] setting and “720p” is selected as the menu itemNo.632 [720p>HD_OUT] setting.626 D/C ENH H000000010dB+1dBFor enhancing the horizontal outlines during down-conversion.0: 0dB1: +1dB627 D/C ENH V000000010dB+1dBFor enhancing the vertical outlines during down-conversion.0: 0dB1: +1dB602 SDI IN MODE00000001DR OFFDR ONFor selecting how to process the serial input.0: The 8 higher bits whose two lower bits have been rounded off are recorded.1: The dynamically rounded 8 higher bit signal is recorded.604 FREEZE SEL00000001FIELDFRAMEFor selecting the freeze mode of the still pictures and the slow play mode.0: Field freeze, field slow1: Frame freeze, frame slow615 V OUT SEL00000001CMPNTCMPSTFor selecting what signals are to be output from the VIDEO OUT1 outputconnector.0: The HD component signals are output.1: Composite signals are output.616 OUT MATRIX00000001YPbPrRGBFor selecting what signals are to be output from the HD component outputconnector.0: The YP BPR signals are output.1: The RGB signals are output.601 VIDEO INT SG000000010002000300040005100%CB75%CBSMPTEBLACKPLLEQFor selecting the type of internal signal.0: A 100% color bar signal is selected.1: A 75% color bar signal is selected.2: An SMPTE color bar signal is selected.3: A black signal is selected.4: The PLL signal is selected. (This signal is used for the adjustments performedbefore the unit was shipped from the factory.)5: The EQ signal is selected. (This signal is used for the adjustments performedbefore the unit was shipped from the factory.)620 DOWNCONMODE 000000010002FIT_VFIT_HFIT_HVFor setting the image processing during down-conversion.0: Side cut mode1: Letter-box mode2: Squeeze mode621 UPCON V MODE000000010002FIT_VFIT_HFIT_HVFor setting the image processing during up-conversion.0: Side panel mode1: Top and bottom cut-off in vertical direction2: Stretch modeVIDEOItem SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settings“ ” indicates the factory setting.